What is the router prompt when in USER EXEC mode?

What is the router prompt for the privileged EXEC mode?

# or Router#

What router prompt can you use the router rip command?

On a cisco router you would go into privilege-exec mode (enable) and then into "configure terminal" mode. From there you can use the router rip command.

A router has a valid operating system and config stored in nvram when the router boots up which mode will display?

user exec mode

Explain the difference between user EXEC and privileged EXEC modes?

Privileged mode has access to the entire router or switch configuration. User EXEC mode only has limited options. Specifically, to do any configuration changes, you need to enter privileged mode first.Privileged mode has access to the entire router or switch configuration. User EXEC mode only has limited options. Specifically, to do any configuration changes, you need to enter privileged mode first.Privileged mode has access to the entire router or switch configuration. User EXEC mode only has limited options. Specifically, to do any configuration changes, you need to enter privileged mode first.Privileged mode has access to the entire router or switch configuration. User EXEC mode only has limited options. Specifically, to do any configuration changes, you need to enter privileged mode first.

Which router mode is accessed by entering the enable mode?

privileged EXEC

Which prompt is associated with the privileged exec mode?

R1#

If a router cannot find a valid configuration file during the startup sequence what will occur?

The router will prompt the user for a response to enter setup mode.

Which router mode is accessed by entering the enable command?

privileged EXEC

What are the cisco IOS modes?

IOS has many different modes, the main ones being user exec and privileged mode. Both usually require authentication to enter. So when you initially telnet into your router you are in basic mode. This allows you to do very few commands, such as ping, telnet to another host, and get statistical information. Access to all configurations are off limits, even for viewing.User Exec ModeWhen you first log in, you are already at user exec mode. You can also tell because you are given the ">" prompt. Privileged Exec ModePrivileged Exec Mode is simply the administration mode for the router. This mode by itself allows you to view router settings that are considered private. To get into the privileged exec mode you must use the enable command. Clue: People with a clue would type 'en' to enter privileged exec mode.The Privileged exec mode is given the "#" prompt. A few of the common commands are listed below:show access-list - displays all access lists and the number of matches each line has received since the access list was applied.show interface - displayes the mani configurations of all interfaces.show interface summary - (IOS version 12.0 and newer) Displays a quick summary of all interfaces.Privileged mode has a a few sub modes as well such as global configuration mode, interface configuration mode, and routing configuration mode, which are described below. You can think of the different modes as a tree that give you more access and more specific configurations as you traverse down the branches.User Exec Mode | Privleged Mode (en) | Global Configuration (conf t) | | Interface (int ...) Routing (route..)

Which names correctly identify the CLI mode represented by the prompt for Switch-East4?

line configuration mode user executive mode * global configuration mode privileged executive mode interface configuration mode * enable mode8 What command is used to change the default router name to Fontana? Router# name Fontana Router# hostname Fontana Router(config)# name Fontana * Router(config)# hostname Fontan

What is the command used to get into global configuration mode on a cisco router?

On user exec mode type enable. When inside the privilege mode type configure terminal. You will then be sitting into global config after this. Please see below example: Router>enable Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#

What are main Cisco IOS Command Modes?

1. User exec mode 2. Privileged exec mode 3. Global configuration mode 4. ROM monitor mode 5. Set up mode