privileged EXEC
**R1(config-router)# network 172.16.0.0 0.0.31.255 area 0
First you must decide what specific protocol you want to use. Then you configure it on the individual routers. Example, with Cisco routers: Router(config)#router rip Router(config-router)#network 10.0.0.0. Router(config-router)#exit Additional commands may be required for optimization. Note: I use RIP for illustration purposes, but it is usually not the best option for routing.First you must decide what specific protocol you want to use. Then you configure it on the individual routers. Example, with Cisco routers: Router(config)#router rip Router(config-router)#network 10.0.0.0. Router(config-router)#exit Additional commands may be required for optimization. Note: I use RIP for illustration purposes, but it is usually not the best option for routing.First you must decide what specific protocol you want to use. Then you configure it on the individual routers. Example, with Cisco routers: Router(config)#router rip Router(config-router)#network 10.0.0.0. Router(config-router)#exit Additional commands may be required for optimization. Note: I use RIP for illustration purposes, but it is usually not the best option for routing.First you must decide what specific protocol you want to use. Then you configure it on the individual routers. Example, with Cisco routers: Router(config)#router rip Router(config-router)#network 10.0.0.0. Router(config-router)#exit Additional commands may be required for optimization. Note: I use RIP for illustration purposes, but it is usually not the best option for routing.
** The router modifies the TTL field, decrementing it by one.** The router maintains the same source and destination IP.** The router changes the source physical address to the physical address of the exit interface
To forward ports on your router just login to your router's on-line interface. Port Fowarding is used when a program (lets use FileFind [not a real program]) requests a port the router doesn't understand. Lets say that FileFind requests port 130 on your router, but your router doesn't have a port 130. It does, however, have a 128. The port forwarding tells the request to port 130 to be routed through port 128.
One example is a router.
privileged EXEC
On a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routing
On a cisco router you would go into privilege-exec mode (enable) and then into "configure terminal" mode. From there you can use the router rip command.
The "enable" command will bring the privilege level from user exec to privileged exec. Example: R1> R1>enable R1#
enable after the Router> prompt
Router(config)#
RouterB(config)# router rip
from the global configuration mode
The login command was not entered on the console line. The enable password should be an enable secret password. No username and password combination has been configured. Console connections cannot be configured to require users to provide passwords
This command enables a strong encryption algorithm for the enable secret password command.
It is the privilege mode.
User enable. router> enable router#