it is simply the voltage of the system
ocr-over current relay(senses the over current in the circuits) efr-earth fault relay uvr-under voltage relay
Medium voltage is over 1000 v, high voltage is over 45 kV.
You can't have a three phase earth fault, you can have a phase to phase or a phase to earth fault. If you want the potential phase to earth fault current it will be your voltage times your impedance. If you want the phase to phase potential fault current then you should just double the above result.
Voltage drop due to the resistance present in the series circuit causes voltage split over a series circuit.
AC card have over/under voltage adjustment for fault. If voltage drop to that range it will trip the fault. Also the unit have voltage adjustment in the bottom right. Voltage coming out of the cable vs voltage coming out Underwood can be different.
It is simply the voltage of the system before the fault occurs.. Most probably this is the voltage of healthy system...
It is simply the voltage of the system before the fault occurs.. Most probably this is the voltage of healthy system...
It the angle between fault current and voltage at the point where the fault occurs.
Most likely a short circuit will cause no voltage. Due to the high current on a short circuit fault the over current protection of the circuit will trip. This will cut the voltage supply off completely.
A Fuse or a circuit breaker can be used to protect an electric circuit from over loads. A surge arrestor / over voltage relay can be provided for voltage protection An ELCB/ Earth fault Relay may be provided for earth fault protection. Electrix Chennai, India.
Low voltage from battery
it is simply the voltage of the system
A fault could generate hazardous parasitic voltages.
Rate of Rise of Re-striking Voltage is a voltage which is found when fault occurs in a power circuit protected by Circuit Breaker. This voltage may be twice the system voltage.
ocr-over current relay(senses the over current in the circuits) efr-earth fault relay uvr-under voltage relay
This is describes the condition at the location a short-circuit fault.