answersLogoWhite

0

remote wire is to control amp, bass coming from subs, and the frequency

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Do you need to hook up the remote wire on your car amp?

Yes a remote wire is necessary. You must wire the remote wire from the amp to and ignition source of power (a component which turns on when the ignition in the car is engaged.) i.e. the radio. The remote wire signals for the amp to power on.


What do you do with the CD player remote wire?

The Remote wire is for the installation of an amplifier. When you install the amp, you have a power (+12V) and ground wire to power the amp, but if you did not have a remote wire, it would drain all of your battery power while you were away from the car (because it would continually suck energy from it); however, without the remote signal coming from the CD player, the amp does not turn on. Does that answer your question? Basically, unless you're installing an amp, don't mess with it.


Where do you connect the remote wire from the amp?

when connecting an amp to your car before you put your dash back together there will be a wire on the back of the stereo that will say remote an that's where you connect it then after all that's down get the song "Broadway" by spm


Where do you put the remote wire on your deck?

You only need the remote wire if you have an external amp.


How do you wire car amp to turn off with radio?

Your amplifier should(hopefully) have an input for a "remote turn on" or some words to that effect. Hopefully your deck has either a "remote turn on" wire or a "power antenna" wire coming out the back of it. If it does, you're in business. Extend it to the "remote turn on" on the amp and you should be good!


Why doesn't your remote wire turn on your amp anymore?

Easy way to check were the problem is take a 6" piece of wire. Unhook the remote wire from your amp. Then hookup your 6" piece of wire to amp remote terminal then take other end and connect to the 12+ terminal. If amp powers up the its in the headunit. If amp does not powerup or goes into protect mode the amp is problem.


How do you put a subwoofer in your car?

You have to run the powers and grounds for the amp, do not forget to set up the remote wire either. then you will need to connect the amp to the CD player auxillary with the RCA's, then you just wire your sub to the amp.-Shocker


What is the remote wire for car stereos purpose?

It runs from your deck to the amplifier. When the deck turns on, it sends a low voltage signal to the amp to let the amp know to turn on. If you are running an amp on a stock stereo, there are other ways to turn the amp on without a remote wire, but that's the easiest way. So, simple answer, it turns your amp on when the stereo comes on.


Which wire is a remote amp turn on wire on a 2012 dodge ram 1500?

The remote amp turn on a 2012 Dodge Ram 1500 is the wire that taps on the harness to supply the 12v.


What will happen if you connect your remote wire to the power wire of your amplifier?

Amp always on


Where does the remote wire from a car amp connect to the car CD deck?

The deck has to be a aftermarket deck. On the wiring harness, you will see a blue wire that says rem. Hook it up there and you should be good


How do you install a amp to a almera?

To install an amp in an Almera, you will need to connect the amp's power wire to the car's battery, ground the amp to a metal part of the car's chassis, and connect the amp's remote wire to a source that turns on when the car is started. You will also need to run RCA cables from the head unit to the amp for signal input, as well as speaker wires to connect the amp to the car speakers. It's recommended to consult a professional for the installation to ensure safety and proper functionality.