answersLogoWhite

0

The Remote wire is for the installation of an amplifier. When you install the amp, you have a power (+12V) and ground wire to power the amp, but if you did not have a remote wire, it would drain all of your battery power while you were away from the car (because it would continually suck energy from it); however, without the remote signal coming from the CD player, the amp does not turn on.

Does that answer your question?

Basically, unless you're installing an amp, don't mess with it.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you find the remote wire in the back of your CD player of a 04 mustang?

usually the blue wire with the white stripe in any CD player


How do you find the remote wire in the back of your CD player of a 98 Malibu?

Usually the remote wire is the blue wire. Although not all CD players have a remote wire. The easy way to find out if you're player has a remote wire is to go onto the manufacturer's website and check the spec's.


Why after buying a new CD player when the radio is on would the subs work but when you put in CD the subs do not come on?

make sure amp remote wire is connected to p.cont wire and not power ant wire on the radio


Why does my amp only work with the radio and not the CD player I have power to the amp with the FM but as soon as I turn on the CD player the amp looses power.?

What it is, is your power ant. wire is hooked to your remote(control) wire of the Amp.To fix this disconnect it and connect it to the remote(control) wire. If you dont have a output labeled as this connect it to the hot wire for the radio. (do not connect it the the constant hot wire there will be two different wires)


What are the CD player wire colours mean?

Red is hotwire, black is groundwire, blue is the remote wire or clock and memory, these are your main wires the rest are speaker wires.


Where does the remote wire enter a kenwood CD player?

The remote wire typically enters a Kenwood CD player through the designated remote control input or terminal, which is usually located on the back of the unit. This connection allows the player to receive signals from a compatible remote control. In some models, it may also be integrated with other wiring connections, such as the power or audio outputs. Always refer to the specific user manual for your model for precise details.


What color wire is the remote wire when using an amp with a factory radio in a 2004 ford f150?

instead of hooking up your amps remote wire to your CD player, i would run the wire to your fuse box and wrap the striped wire around a fuse for something like the windshield wipers or acc or something that turns on when you want your amp on. and then put the fuse back in and then it's the same as plugging it into your CD player, except not as much work


What is dual CD player wire color codes?

What is dual CD player wire color codes?


What does the remote wire hook up to on the back of a CD player?

It is most likely for a remote control accesssory that allows you to perform normal CD playback functions with a controller wired to the player. For example, you can sit in your chair and adjust the volume or skip songs without getting up and going to the player. The remote wire goes to the amp. its the turn on switch from your deck to your amp. if your not running an amp, then put electrical tape around the wire , so it doesn't touch any metal and ground out.


How do you install a CD player in a 1999 cavalier Z24?

you cut the yellow and black wire from the origanal plug and wire these from the CD player wire the yellow, red, blue, wire into the yellow and the black from origanal plug to black on CD player


What to do when your CD player reads err?

Re plug your CD player wire Or try to check another CD.


How do you wire an amp and sub to a c240?

Run your power, ground, and remote wires. Then connect your RCAs to the back of your CD player and your amp, then connect your speakers to the amp..-Shocker