ohms.... the symbol looks like a cattle brand, kinda
Yes they do have a resistance. Even though a battery is a voltage source it has some thevenin resistance. Every lead plate and cell of sulfuric acid, will have a small resistance. The thevenin resistance is equivalent or sum of all those resistances.
A: TO measure the current on any path you will need a very small known resistance in sires and measure the voltage drop across it. If the resistance i not small then inaccuracy of reading will be evident
You measure it indirectly using a known load resistance and measuring supplied current. Loading of the ammeter should be known as well, and the load resistance should be made relatively small to get accurate results.
Voltage is current times resistance, 1.2 x 110 = 132 volts.
A: That small coil is micron wire it has resistance. Current trough it makes it to glow
It is not a shunt with zero resistance. It is very small, but it is not zero. The large current develops a small voltage across the small resistance. Measuring that small voltage gives you a proportional measurement of the current.
-- Connect a source of known, small voltage across the ends of the unknown resistance. -- Measure the resulting current through the unknown resistance. -- Divide (small known voltage)/(measured current). The quotient is the formerly unknown resistance.
Transportation
Yes they do have a resistance. Even though a battery is a voltage source it has some thevenin resistance. Every lead plate and cell of sulfuric acid, will have a small resistance. The thevenin resistance is equivalent or sum of all those resistances.
Arterioles generally have the highest resistance because they are so extremely small.
no internal resistance of a cell cannot be considered to b as a defect because the resistance is so small as compared to the output we get from a cell this ristance can be neglected..
Platinum resistance thermometer requires a small current to pass through it to determine its resistance at different temperatures. Platinum has a linear resistance-temperature relationship; we can use this method to find the resistance at different temperatures.
The resistance of a wire is the length divided by the cross-section area and the conductivity of the material. So for small resistance you need a wire with short length, large cross-section area (diameter) and a material with high conductivity like copper.
Resistance of a short circuit is actually very low, ideally it is 0 Ohms. In practice the resistance of a short circuit will be equal to whatever the resistance of the short circuited wires is, which is typically very small. So if you substitute very small resistance value R into Ohm's Law(I = V/R), you will get a very high current flowing. Where V=voltage,I=current.
A: TO measure the current on any path you will need a very small known resistance in sires and measure the voltage drop across it. If the resistance i not small then inaccuracy of reading will be evident
A shunt resistance is a low resistance connected parallel to the galvanometer so that a large portion of current passes through the low resistance and a small fraction of current passes through the galvanometer this saves the galvanometer from damage
Aerate the water: pump lots of small air bubbles into it.