0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the ratio of average shear stress to maximum shear stress for a circular section?
the average shear stress is 3/4 the maximum shear stress for a circular section
Introduction of chip thickness ratio and shear plane angle during machining?
shear plane angle is Eric siangco + hulian lastontas = shear plane angle
How does shear strength of fine sand effect by void ratio?
Shear strength of fine sand is determined by the angularity of the sand particles, the grading of the sand. These two features governs the critical state shear strength parameters of the sand. Density, however, dictates the peak shear strength of the sand. i.e. the denser the sand, the higher the peak shear strength. But the critical shear strength remain the same. The denser the sand, the lower the void ratio. Shear strength of fine sand is determined by the angularity of the sand particles, the grading of the sand. These two features governs the critical state shear strength parameters of the sand. Density, however, dictates the peak shear strength of the sand. i.e. the denser the sand, the higher the peak shear strength. But the critical shear strength remain the same. The denser the sand, the lower the void ratio.
Which types of soils the vane shear test is applicable?
how use the result of vane shear test
Why is the maximum bending moment of a structural member as the point of zero shear?
Shear is the rate at which bending moment changes or shear is its derivative with respect to span. The integral, bending moment, goes through a maximum when shear goes from positive to negative or vice-versa.
How do you remove key from blower shaft of john deere snow blower?
There is only a shear pin
Is lawn mower backfiring bad What can be damaged?
Flywheel key (or shear pin) can shear off which will put the motor out of time and wont start . It could do damage to some other parts but that is the most common.
What to do when a mower blade is loose and nut is tight?
Depending on your blade - you probably sheared the shear rivets, bolts or key.
Why are splines are better than keys?
Splines are stronger than the shear strength of a key. More than one key would be stronger than one. eD
Relationship between the shear stress and angle of shear?
Shear Stress divided by the Angle of Shear is equals to Shear Stress divided by Shear Strain which is also equals to a constant value known as the Shear Modulus. Shear Modulus is determined by the material of the object.
Does it hurt when the lawn mower backfires?
hurt no, if you pulled your cord and it jerked your arm and hurt you have a shear fly wheel key.
What is a homophone for shear?
A homophone for "shear" is "sheer".
What is negative shear and Positive shear?
The difference between a positive shear and a negative shear is the direction the image is distorted into
Definition of hooke's law in shear?
shear stress (t) is proportional to shear modulus (G) x shear strain (h) or t = Gh where h is shear angle/length
What is shear vane?
Shear vane is a tool used to measure the shear strength of soil.
What is the homophone of sheer?
Shear is the homophone for sheer. An example sentence for shear: One of his duties on the farm was to shear the sheep.
Is punching shear either one way shear or two way shear?
two wayshear
