Something that is "Spalling resistant" will be less likely to chip or break off.
Something that is "Spalling resistant" will be less likely to chip or break off.
Spalling: To break into fragments or small pieces."Spalling can be described as the breaking of layers or pieces of concrete from the surface of a structural element when it is exposed to the high and rapidly rising temperatures"
good quality sealed joint and cracks
bomblet detonation bomb fragmentation all
find theany spalling for y.s.m.o.a.h.n
Abrasion and hot/cold thermal spalling.
unsitable cover for concrete reinforcement
corrosion and erosion due to lack of heat transfer
sounds like erosionA2. This describes freeze-thaw spalling of rocks.
The problem that you face is external rather than internal in that spalling usually happens where the internal surface freezes but that seems so unlikely There are a number of epoxy-resins and similar concrete repair products on the market as since I'm in England I can only give you generic keywords to search on If it is possible, I would advise you to install some sort of land drainage around the property like a gravelled trench to drain away the excess water that settles in the wall That should remove the cause of the spalling
There are multiple causes to intake and exhaust valve damage. These include preÊdetonation (knocking) and valve guide wear causing tracking issues.Ê
8mm steel plate. And no, it did not work very well as armor. When a bullet struck it, if it did not go all the way through, bits of steel flew off the inside (known as spalling)