0
They are used for putting threads on screws / bolts or, for putting threads in holes.
Taps put threads in holes. You can actually get a combined drill and tap.
I have added a link under related source so you can see what they look like
What else can I help you with?
What made my 1992 Toyota Corolla go tap tap tap TAP TAP TAP and POP then die?
The gas you put on it last week.
When did Wim Tap die?
Wim Tap died on 1979-09-24.
Can you die from being submitted and not Tap-out?
no not really
Can you have tadpoles in tap water?
no cause if do they die so u leave the tap water out for about a week cause tap water has a chemical in it that will harm the tadpoles
Why does the mosquito's eggs die in mineral and tap water?
Mineral and tap water do not have the tiny insects that mosquitos feed on.So, the mosquitos' larve would die from starvation.
What will happen if you have gave a snail tap water?
they will die :(
How can a bolt be rethreaded without using a rethreader?
To rethread a bolt without a rethreader, you can use a tap and die set. This involves using a tap to create new threads on the bolt and a die to clean up existing threads. Be sure to use the correct size tap and die for the bolt you are working on.
What is the difference between a rethreading kit and tap and die kit?
A rethread kit cleans up damaged existing threads. A tap and die kit makes threads from scratch.
Can you just put the saltwster fish in tap water with salt?
No you can not because tap water has chorine that makes fish die
In what way did a drummer from This Is Spinal Tap NOT die?
Airplane crash
How do you use a tap and die?
To use a tap and die, first select the appropriate size tap and die for the screw or bolt you need to create or repair. For tapping, secure the workpiece and drill a hole with the correct diameter, then insert the tap into the hole and turn it clockwise using a tap wrench, applying even pressure to cut threads. For die, secure the rod or bolt in a vise, place the die over the end, and turn it clockwise, again applying even pressure to create external threads. Always use cutting oil to reduce friction and ensure a smoother process.
How do you determine what size tap die to use on a 10mm bolt broke off by thermostat of Ford Taurus?
Compare the tap and die to the other bolt. make sure u comapre the threads.
