An interrupt is a mechanism for hardware of software to interrupt the processor to go do something else.
Playing music is a much higher level abstraction, and it is not valid to ask what is the interrupt to play music, partly because it depends on the specific hardware implementation.
Actually By Default this is present in BIOS(ROM) and at the boot time Operating System loads it to the RAM.
queue of 8086 microprocessor is 6 bits
The 8086/8088 is a CISC based architecture.
By checking the interrupt register at fixed time intervals
Intr timer interrupt 0 and 1 external interrupt 0 and 1
8086 have 5 interrupt lines.
No. RST7.5 is a maskable interrupt on the 8085, not the 8086/8088.
The 8086 interrupt priorities are concerned ,software interrupt have the highest priority,followed by NMI ,followed by INTR.The lowest priority signals are unmaskable interrupts.
Interrupt vector table
The BIOS function in the 8086 microprocessor is called an interrupt function. It is an interrupt function because it is not called by a function call instruction.
There are 256 different interrupt vectors in the 8086/8088. Each vector is a far CS:IP address, which is four bytes. That makes the interrupt vector table 1,024 bytes.
The 8086 interrupt table is from 0000h to 03FFh for interrupt 0 through interrupt 255. It is common practice to design systems that use only the lower-numbered interrupts and then use the upper part of the interrupt table for code or data. For more information see: http://datasheets.chipdb.org/Intel/x86/808x/datashts/8086/231455-005.pdf
Interrupt Acknowledgegenerated by the microprocessor in response to INTR. Causes the interrupt vector to be put onto the data bus
In the 8086/8088, the interrupt vector table is the first 1024 bytes of memory. In the 8085, the interrupt vector table is the first 64 bytes of memory if using the RST form of interrupt, otherwise the interrupt vector is provided by the interrupting device, usually in the form of a CALL instruction. The interrupt handler is wherever the interrupt vector points to.
Type-2 interrupt is called NMI (Non-maskable interrupt).May occur when 8086 receives a low to high transition on it's interrupt response.Could be used for handling critical situations like power failure detection.
The interrupt vector table in the 8086/8088 is the first 1024 bytes in memory. There are 256 vectors, each containing 4 bytes, CS:IP, for each possible interrupt source.
There is no parity interrupt on the 8085 or 8086/8088. If you mean a memory parity interrupt, that is a function of system design, not a function of the particular microprocessor involved. Generally, a memory parity error is fatal, so one would typically place it on a non-maskable interrupt, such as TRAP on the 8085, or INT 2 (NMI) on the 8086/8088. This assumes, of course, that the memory parity error does not just crash the processor.