Want this question answered?
An air-break link (ABL) switch is designed to interrupt normal load currents (but not fault currents). In order to do so, they usually incorporate some form of very simple arc-extinguishing feature.An isolator switch, on the other hand, is not designed to interrupt current, but to isolate equipment after that equipment has been disconnected (e.g. by opening a circuit breaker).
An SPN isolator switch is a circuit breaker; they are a device, which when used can automatically switch off the flow of electricity. They are used to protect a piece of machinery or equipment from damage by an overload of electricity.
On load switching is when a switch can be operated whilst current is still passing through the switch (i.e. it is on load) Offload switching is when a switch is operated whilst there is no current through the switch (i.e. it is offload)
no difference whatsoever
Both are types of isolators of a power circuit. Load break switch is an isolator where circuit can be isolated on load. The quenching media could be air, oil or gas..... Air break switch is type isolator where isolation takes place in the air itself. (break contacts are not immersed in oil, gas ...) But whether these isolators can be opened on load or not can be said only by looking at the desgin data. Some isolators are designed to open and close on load.
go to www.howstuffworks.com
An isolator is just a disconnector ; it disconnects the load from the supply. The method of operating the isolator can be through a handle or through a spring or through a motor. Isolators can be on-load isolators , which can be switched off on load , or they can be off-load isolators which should not be switched off on load. A Miniature Circuit Breaker can break or open in the event of a fault. Thus its load carrying capacity is extremely high , up to 10 kiloamperes or more. What this means is that if a short circuit current to the tune of 10 kA flows through an isolator , it will melt the isolator contacts , and the damage can be irrepairable. When the same current flows through an MCB , the breaker will trip , without suffering any permanent damage. Thus an MCB is a protective device.
What_is_the_difference_between_proxy_switch_sensor
An SPN isolator switch is a circuit breaker; they are a device, which when used can automatically switch off the flow of electricity. They are used to protect a piece of machinery or equipment from damage by an overload of electricity.
Both are same...
When installing an isolator switch enclosure, make sure that the terminations are tight and secure.If you are using the isolation switch to disconnect a load that must be worked on the following should be checked. Make sure that the handle of the switch is down and locked in the off position. For isolation switches that have windows in the front of them look and make sure that the switch blades are physically in the open position. Then lock the switch in the off position. Always safety first.
Technology wise there is no such difference.