0
clc
close all
n=input('enter the length of ramp');
t=0:n;
plot(t);
xlabel('t');
ylabel('amplitude');
title ('ramp')
The above code can generate ramp signal using Matlab.
Wiki User
∙ 11y ago
To generate a ramp signal in MATLAB, you can use the "linspace" function to create a vector of evenly spaced values, and then multiply it by the desired slope and offset. Here is an example code that generates a ramp signal with a slope of 2 and an offset of 1:
t = linspace(0, 1, 100); % Create a vector of 100 evenly spaced values between 0 and 1 ramp_signal = 2*t + 1; % Multiply the vector by 2 and add 1 to generate the ramp signal with slope 2 and offset 1
Add your answer:
Earn +20 pts
Unit ramp in matlab?
This following loop creates a unit ramp input : for t= 0:0.1:5 if(t<=1) y(count) = t; end if(t>1) y(count) = 1; end Rz(count) = tf(y(count)*T,[1 -2 1],T); Rs(count) = d2c(Rz(count)); end % T = 0.005; this is for a discrete system
How do you work out the gradiant on a ramp?
Divide the height of the ramp by the length of the ramp (rise over run).
Which has a greater mechianical advantage short ramp and a long ramp both reach a height of 1m?
The long ramp.
How do you use ramp in a sentence?
I rode on a big RAMP with my bike.
What are the uses of a inclined plane?
The inclined plane is used for things such as a loading ramp, handicap ramp, bike ramp etc.
How can you generate blanking and raster ramp signal using fpga?
Blanking Means it's a Zero signal. But that zero signal is operate some V volts.
Is ramp signal energy or power signal?
no...it is neither energy nor power signal . Rampis neither energy nor power signalbecause it has infinite energy as well as infinite power.....saket kumar (electronics & communication engineer),BMSCE MUKTSAR (PUNJAB).
What is ramp rate?
We are calculating the response time of the ramp input signal (temperature), ramp rate is a Temperature varies linearly with time.
Can you stop on a freeway on ramp if necessary?
You CAN stop on a freeway ramp. Sometimes it's mandatory, like when the ramp signal is red, or if there is a traffic jam on the freeway. You should not stop on a freeway ramp if you can help it because you are risking a ear end collision.
What is the Laplace transform of unit ramp signal?
normally the unit ramp signal is defined as follows... r(t)= t, t>=0 0,otherwise so the laplace of it is given as R(s)=1/s^2
WHAT IS Blocking wheelchair access ramp to sidewalk CA VEH CODE 22500L?
It is when your vehicle is obstrucing a wheelchair ramp, this can occur while you are parked or even stopped in front of a wheelchair ramp.
How do you enter traffic flow?
Do not stop on the ramp get on the gas and go if you have some where you can go at all and use your turn signal.
what angle or degree must a handicap ramp have in order to pass code in Va.?
The portable ramp must be at least 42" wide and have a slope of 8 percent in Virginia.
Unit ramp in matlab?
This following loop creates a unit ramp input : for t= 0:0.1:5 if(t<=1) y(count) = t; end if(t>1) y(count) = 1; end Rz(count) = tf(y(count)*T,[1 -2 1],T); Rs(count) = d2c(Rz(count)); end % T = 0.005; this is for a discrete system
Directions to Ralph Wilson Stadium in Buffalo from Niagara falls?
FROM PEACE BRIDGE (CANADA)Head south on 190 to 90 West, follow to Exit 55 (Route 219). Exit 219 on Milestrip Road West Exit. Be prepared to stop at the end of the ramp. Counting the signal at the end of the Milestrip ramp, go to the 3rd signal and make a left turn onto Abbott Road to the stadium.
Example of a ramp?
One example of a ramp is a wheelchair ramp.
Difference between function generator and signal generator?
A signal generator provides a high-fidelity sine wave signal ranging from low frequencies to many GHz. Attenuation, modulation, and sweeping are typical features of a signal generator.A function generator is a lower-frequency instrument that typically provides sine, square, pulse, triangle and ramp waveforms. Function generators provide these standard functions from DC to a few MHz, and provide large voltage ranges.
