(Rossi 62 S.A.C. .22cal) }
O.D. (Outside Diameter) is: }
mm = 11.38 }
in = 0.448 }
------------- - Bob Catt
(Rossi 62 S.A.C. .22cal) } Tucson, AZ.
I.D. (Inside Diameter) is: }
mm = 8.13 }
in = 0.356 }
------------- -
(Rossi 62 S.A.C. .22cal) }
O.A.L. = 16.25"
NB = inside diameter of the tube. OD = outside diameter of the tube.
There are five syllables like so: pe-ri-od-i-cal.
wall thickness of pipe is (OD - ID) /2
6.62
Found at about.com: http://interiordec.about.com/od/buyingabed/a/a_bedsizes_3.htm
Junior Colt .25 with that serial number was made in 1973.
The primary difference between pipe and tubing is how the size is designated. Pipe is designated by a "Nominal Pipe Size" based upon the ID (inside diameter) of the most common wall thickness. Tubing is designated by the measured OD (outside diameter). For Example: A 3/4 inch iron pipe has an OD of 1.050 inches, while a 3/4 inch steel tube has an OD of 0.75 inches. The Copper industry calls all cooper tubular products "Tubes" but they designate a "Type". Each type has specified OD and ID dimensions The size of a tube is determined by it's OD and the thickness. The actual OD of a tube is just the same as it's nominal OD. A certain size of a tube will keep the same OD no mater what the thickness is. It is true for pipe except that the actual OD is larger than it's nominal OD. For example, for a 1" schedule 5s pipe, the actual OD is 1.315", the thickness is 0.065" and the ID is 1.185". When it's thickness is schedule xxs (0.358"), then it's ID is reduced to 0.599" while keeping it's OD. Furthermore, the actual OD of a pipe is just the same as it's nominal OD when the size is the same as or larger than 14" per ASME/ANSI B36.10/19 . Consequently, both the size of tube and pipe is measured by it's OD and the thickness. Actually tube is used when we need to transfer heat from its walls and we want this to be happen while in pipes we try to stop the heat transfer such as we use tubes in boilers because we make steam we need to transfer the heat while when we transport steam we use pipes because we wana save heat energy. 2: pipe can be thick according to formula d/t >10 while tube will must thin according to this formula. The Real Difference: Sorry to say; wrong! Pipe and tube is ever so simple. Pipes are used to transport something, and tubes to construct something; hence, tubes are defined by the od "outside diamater" and wt "wall thickness" (for construction stability), and pipes id inside diamater to allow a calculation for transportation viz., speed, volumes etc. (od = id + 2 * wt).
The word method has two syllables. The syllables are meth-od.
I have researched this subject and found several good websites on the subject. This the most informative I looked at. sportscareers.about.com/od/careerpaths/a/sprtwriterprof.htm
July 25, 1978 Source: http://history1900s.about.com/od/medicaladvancesissues/a/testtubebaby.htm
Pipe is identified by NB and thickness is defined by Schedule whereas Tube is identified by OD. For more detail about piping click here : http://pipingguide.blogspot.com/
OD has 2 meanings you can OD(over dose) or the slang way OD(over doing it) OD also stands for "Organizational Deevelopment"