Connecting an ammeter in parallel subjects that ammeter to the full supply voltage. The shunt resistor is not designed to sustain that value of voltage and will burn out. Also, the clue is in the word 'shunt' (which means 'in parallel') which means that the coil will also burn out!
An ammeter, either shunt or inductive. A shunt is an inline resistor of a small, known resistance. Knowing the resistance and the voltage one can calculate the amperage by Ohms law, I=V/R. An inductive, or clamp on ammeter measures the magnetic field and using more complex calculations displays the current, typically on a digital display.
To measure the current in a DC circuit an ammeter may be used. This ammeter may consist of a sensitive meter with a shunt in parallel with it to divert part of the current. In case even more current is expected than the full scale reading of the meter an additional shunt may be connected in parallel with that arrangement.
it can be used as a ammeter, voltmeter and also as a ohmmeter.
it gets a bigger chance of giving wrong result. ANSWER Absolutely not in series the meter will read the same no matter where it located in the series circuit. the same meter cannot be placed in parallel to measure.
Connecting an ammeter in parallel subjects that ammeter to the full supply voltage. The shunt resistor is not designed to sustain that value of voltage and will burn out. Also, the clue is in the word 'shunt' (which means 'in parallel') which means that the coil will also burn out!
A shunt is connected in parallel with an ammeter. Any current applied to parallel devices will divide betwen them, so the ammeter will pass only a part of the total current.
aryton shunt in a multirange ammeter is basically a bunch of resistors(shunt) connected together in parallel to the Dc ammeter and a selector switch in order to basically extend the range of the current...
because lots of current is likely to be flowing through them.however a shunt ammeter is easier to build than the direct ammeter as described above. in a shunt ammeter you use an ordinary meter wound with fine wire and put a small value shunt resistor across it to take almost all the current.
to increase the sensitivity for the same damping torque
With an ammeter or a shunt.
A galvanometer with a low resistance shunt in parallel makes an ammeter.
Actually ammeter is a galvanometer which is shunted by a resistance called shunt. For large currents major part of it is bypassed through the shunt. The parallel combination of shunt resistance and meter resistance is added to the circuit resistances , so the value indicated by the ammeter is slightly lesser than the actually value.
Since Galvanometer is a very sensitive instrument therefore it can't measure heavy currents. In order to convert a Galvanometer into an Ammeter, a very low resistance known as "shunt" resistance is connected in parallel to Galvanometer. Value of shunt is so adjusted that most of the current passes through the shunt. In this way a Galvanometer is converted into Ammeter and can measure heavy currents without fully deflected.
Multi-range ammeter using universal shunt
An ammeter's coil requires very little current for full-scale deflection (fsd). So, to measure a current above its fsd value, most of that current must be allowed to bypass the coil. This is achieved by placing a very low value shunt resistance in parallel with the coil ('shunt' is an archaic word for 'parallel').
An ammeter measures the electrical current in something. A digital one is calibrated to display through the shunt and convert information from the analog model.