Looking at the front of the car the order on the block at the back would be 1,3,5 the front of the block closest to you would be 2,4,6. The wires on the coil from left to right looking from the front of the car would be 1,4,6,3,2,5.
Yes
what size motor you have,its a 2.2.thanks brian
can i pull a chevy caviler motor 1998 2.2 4cylinder from the top or do i have to drop it from below
I own an 84 trans am. In the 85 models typically there will be a 5.0 leter V8.
Which mount are you looking for? There are two, the upper mount and the lower dog bone mount.
change the blower motor resistor . this controls the speeds . thanks paul
What is the spark plug gap for a 9.9hp mercury outboard motor
well the real question is do you have spark are you getting fuel? well you can take and roll the motor oveer and then pull the spark plug. if the spark plug is wet you don't have spark if the spark plug is dry you have spark that's the easiest way to take a look. the motor need three thing to run fuel oxygen and spark. DO NOT ROLL THE MOTOR OVER WITH THE SPARK PLUG OUT OF THE CYLINDER YOU WILL MORE THAN LIKELY LIGHT THE FUEL THATS PUSHED OUT OF THE MOTOR IN THE COMPRESSION STAGE. when you find out if the motors getting fuel and not spark it could be your crank sensor which tells the motor when to ignite the spark plug to cause your explosion which makes the motor run. i hope this was helpful.
This depends if done by a Hardworking ASE certified mechanic as little as 10 hours! But typically a motor from a later model car such as that takes two days to complete!
Motor sensory
Fuel, compression and spark.
If you reinstall a three-phase motor with two of the supply conductors interchanged, then the resulting negative phase sequence will cause the motor to run in reverse.