Want this question answered?
80 ft pounds
Head bolt torque Tighten in the following stages 1. 29Nm 2. 69Nm 3.Slacken bolts by 180 degrees 4. Slacken bolts a further 180 degrees 5. Bolts 1 and 2 to 34Nm 6.Bolts 3-6 to 15Nm 7. Tighten all bolts by 90 degrees 8. tighten a further 90 degrees Sequence 5 2 4 3 1 6 3 1 6 5 2 4 Bolts 5 3 3 5 are the flywheel side of the engine.
Torque Stage 1. 20Nm Stage 2. +180 degrees Stage 3. +180 degrees Sequence 9 5 1 3 7 10 6 2 4 8 Bolts 7 & 8 are flywheel side of engine
Drop the transmission and it should be 4 or 5 bolts holding the flywhewl on
Sequence 9 5 1 3 7 10 6 2 4 8 bolts 7 & 8 flywheel side of engine Torque Stage 1. 20Nm stage 2. +180 degrees Stage 3. + 180 degrees.
316i engine code 16 4E2 Head bolts must be renewed Torque settings stage 1. 30Nm stage 2. + 90 degrees stage 3. + 90 degrees Tightening sequence 7 5 1 3 9 10 4 2 6 8 Bolts 7 & 10 are the flywheel side of the engine
Sequence 7 1 3 5 8 4 2 6 bolts 5&6 are the flywheel side of the engine Torque Stage 1. 40-45Nm Stage 2. 85-90Nm.
Torque settings Stage 1 .20 newton metres stage 2. +180 degrees stage3. +180 Degrees Sequence 9 5 1 3 7 10 6 2 4 8 Bolts 7 & 8 are the flywheel side of engine hope this helps Mike 2
Tighten the1/4 inch bolts 7-9 ft. lbs of torque, and the 5/16 bolts to 12 ft. lbs. torque.
Bravo 1.2 engine code 182B2.000 Torque Stage 1. 20Nm Stage 2. 30Nm Stage 3. + 90 degrees Stage 4. + 90 degrees Sequence 8 6 2 5 10 7 3 1 4 9 Bolts 9 & 10 are flywheel side of the engine.
5/16 bolts 25 ft/lb
pull the trans. and ther are 5=6 bolts