Around 7 ft/lbs
It's 89 in. lbs.
89 inch lbs. or 7.44 ft. lbs of torque
According to Chilton's, the Specification for the Spark Plug Tube Nuts, Which bolts the valve cover on, is 33 lbs. The socket size is 30mm. However, I was told by a friend of mine who is a mechanic that he tightens them at 20 lbs.
It's on the valve cover
due to its high initial torque value. the DC series motor is a Constant power motor, equal to the RATED POWER if it has at rated value of the U and I. Angular velocity=Rated Power/Torque, so Torque =Rated Power/Angular Velocity thus, in the start the velocity is zero or near, so, the Torque is infinit or very higt
due to its high initial torque value. the DC series motor is a Constant power motor, equal to the RATED POWER if it has at rated value of the U and I. Angular velocity=Rated Power/Torque, so Torque =Rated Power/Angular Velocity thus, in the start the velocity is zero or near, so, the Torque is infinit or very higt
ondo valve cover, bolts remove valve cover, remove old gasket from valve cover and block. clean both surfaces well. put gasket glue on one side of gasket and install on cylinder head. align valve cover than replace bolts . tighten in a cross pattern until thet are snug. don't overtighten.
Its near the valve cover, there should be a small, L shaped hose coming from cover that's about 2 inches long, and it goes right into the PVC Valve
On the drivers side engine valve cover , towards the rear
M20 -bolt, what is the torque value M24 M24
300kgf.cm
Small elbow in the top of the valve cover.
it is on the back valve cover, you can't see it unless you remove the intake plenum.