Resistance is the ability to regulate the amount of charge flowing in a circuit.
For parallel circuit , each & every component shares 2 common connections . But for series circuit , each of them share 1 common connection .In electrical , each component has their own amount of current flowing through ( depending on the resistance of each ) and sharing the same voltage drop for parallel circuit . In case of series circuit , each component shares the same amount of current with each other & the voltage drop across each of them is different ( depending on their resistance ) .
the resitance would be used to reduce a voltage amplitude to a level suitable to be used in an application, to limit the amount of current flowing within the circuit , or in some cases the resistor could be used as a heating - effect.
resistors, variable potentiometers
An ammeter has to measure to current flowing through the circuit. Resistance offers an obstruction to the current flow. So, if the resistance of an ammeter is large , the current measured by the ammeter will be quite less as compared to the actual amount of current flowing through the circuit which is undesirable. If ammeter has zero resistance , then it will give the exact value of current. But this is not practically possible because every material has some value of internal resistance which we can't control. For this reason , ammeter must have small resistance
we use the inductor because it helps the circuit to have an appropriate amount of current, so that the circuit in the appliance will say longer.
Resistance
resistance
yes
An ammeter measures the amount of current flowing in a circuit
An ammeter measures the amount of current flowing through an electrical circuit. It measures amperage.
It depends on the resistance (or impedance) of that branch alone.
The advantages of a moving iron ammeter is that it can accurate measure the amount of electricity which is flowing. This makes it well suited for both monitoring and controlling the amount of electricity in a circuit.
yes. A GFCI monitors the amount of current flowing from hot to neutral. If there is any imbalance, it trips the circuit.
The stronger the magnetic field on your inductor the greater amount of current you will have flowing through your series circuit.
Too much light overwhelms the eye's ability to distinguish contrast and therefore detail in the specimen. Microscopes therefore have the ability to reduce the amount of light impinging on the specimen using a diaphragm, rather like the iris of the eye does.
The amount of water in the stream and the gradient. However if you had two streams both with the same amount of water in them but with one stream flowing down a steeper slope (gradient) than the other, then the steep one has more ability to erode.
Circuit Breakers and Fuses limit the amount of current flowing through the circuit.