0
What is the average cost of parts and labor to change the power steering hose on a 1998 Oldsmobile achieva?
it ranges between $90.00 and $120.00 for a new Power Steering pressure hose, parts and labour, I had 3 estimates done. it takes about an hour for it to be finished depending on how busy the garage is , i got mine parts and labour for $86.98
What else can I help you with?
How do you replace the water pump on a 1995 Oldsmobile Achieva?
is it hard to change the water pump on a 1992 Oldsmobile achieva. Yes, it is very hard to replace a water pump on an Achieva. When the pump died on my 1996 Achieva, the engine needed to be unbolted and removed to get to it. As I recall, it cost about $500. I have a 95 Olds Achieva 3.1 and the water pump was very easy to change. Mine is on the front passenger side of the engine. Very easy to get to, just be careful not to break any bolts off. lol
Change power steering pump 96 Oldsmobile 88?
how to remove powersteering pump
How do you change headlight on Oldsmobile Achieva 96?
To change the headlight on a 1996 Oldsmobile Achieva, first, open the hood and locate the headlight assembly. Remove the retaining clips or screws securing the assembly, then carefully pull the assembly out. Disconnect the wiring harness from the back of the headlight bulb, replace the bulb with a new one, and reconnect the wiring. Finally, reinsert the headlight assembly and secure it back in place.
How do you change belt for 1997 Oldsmobile achieva?
To change the serpentine belt on a 1997 Oldsmobile Achieva, first, ensure the engine is off and cool. Locate the tensioner pulley and use a wrench to rotate it, relieving tension on the belt. Remove the old belt, noting the routing path for the new one, then install the new belt following the same path. Finally, release the tensioner to secure the new belt in place.
How do you change brake pads on a 1997 Oldsmobile Achieva?
To change the brake pads on a 1997 Oldsmobile Achieva, start by lifting the car and removing the front wheels. Next, remove the caliper bolts and slide the caliper off the rotor. Take out the old brake pads and replace them with new ones, ensuring they are properly aligned. Finally, reattach the caliper, tighten the bolts, and reinstall the wheels before lowering the car.
How do i change an ac drier in an Oldsmobile achieva?
To change the A/C dryer in an Oldsmobile Achieva, first ensure the A/C system is fully discharged to avoid refrigerant exposure. Disconnect the battery, then locate the A/C dryer, typically mounted near the condenser. Remove the mounting bolts and disconnect the refrigerant lines, taking care to replace any O-rings to prevent leaks. Install the new dryer, reconnect the refrigerant lines, and recharge the A/C system with refrigerant.
I replaced the brake pads and one of the rotors on my 1996 Oldsmobile achieva and now the brakes won't work at all. I'be tried bleeding the brakes and no air is coming out but there's still a problem.?
change that calipers
Power steering pump removing on a 1995 Oldsmobile 88 royale?
this has to be done in order to remove the last bolt on the water pump in order to change that.
Change brake pads on 1994 Oldsmobile Achieva?
Changing brakes is a simple task. Lift the car, remove the wheel, remove the brake shoe, replace the pad, replace the shoe, replace the wheel and lower the car.
How do you change a cam sensor on a 97 achieva?
To change the camshaft position sensor on a 1997 Oldsmobile Achieva, first disconnect the negative battery terminal to ensure safety. Locate the cam sensor, which is typically found near the engine's timing cover. Remove the electrical connector and unscrew the sensor from its mounting. Install the new sensor in the reverse order, reconnect the electrical plug, and reattach the battery terminal.
Where is the fuel filter located on a Oldsmobile Achieva?
the filter is under the car even with the rear tires coming a few inches out from the gas tank there are two lines going to the tank one has the filter on it its very simple to reach and change
Will a 95 Oldsmobile achieva motor fit a 2000 grand am?
You will have to change the computer and wiring harness I believe. The 95 is most likely an OBD I, and the 2000 is an OBD II. If it is one of those OBD I and a half, or whatever they called them, you will still have to swap the computer and wiring harness. I don't know if GM used the I and a half on the Achieva, but they did on the S10 Blazers in 95.
