Want this question answered?
A spirochete can move by rotating its axial filaments.
Shaft center to center
Axial displacement is the motion along the shaft of the turbine caused by the force exerted by the steam or by the thermal expansion of the shaft and casing.
Rotating axial compressor.
it is the bearing that holds the shafts while it is rotating.
Franklin K. Moore has written: 'Research on rotating stall in axial flow compressors. Part IV. A preliminary study of three-dimensional rotating stall'
The Earth rotating causes day and night, it rotates every 24 hours. The Earth rotating causes day and night, it rotates every 24 hours.
The centrifugal flow compressor has a single or two stage unit using an impeller. The axial flow compressor is a multi-stage unit using alternate rows of rotating (rotor) blades and stationary (stator) vanes.
In axial flow pumps, fluid enters and exits along the same direction parallel to the rotating shaft giving high flow rates and low head. In radial flow pumps, fluid enters and leaves perpendicular to the rotating shaft giving high head and low flow rates. Thus, in mixed we have combined of both axial and radial.i.e.Liquid will go behind the impeller at certain angle between 0-90degrees normally below 45degree.Mixed flow replace axial when we require head not provided by the axial pump as we have to lift water from a water a lower level and then discharge it. physically,mixed flow can be identified by bellmouth(diverging converging shape) which shows its between axial and radial. BILAL BIN NASIR
Because the "pole star" is aptly named due to being located at Earth's pole. The pole is the axial point where Earth is rotating so anything located at the pole will appear as though it is stationary.
The Jet engine was invented simultaneously by an Englishman and German, however neither knew of each others work and they both designed a completely different engine. English Sir Frank Whittle invented the radial flow engine, whereas the German Albert Fonó invented the axial flow engine. Both engines were successful, however the axial flow princable is used mostly today.
It is axial.