answersLogoWhite

0

Because of Ac supply, current lags voltage by 90 in Inductor.

User Avatar

Wiki User

∙ 17y ago
User Avatar

What else can I help you with?

Related Questions

What does a inductor do when connected across ac supply?

opposes changes in current


If an inductor and a switch are connected in parallel through which the current will flow in an AC circuit?

A:The inductor does not allow ac signal to pass through. It blocks ac and passes dc. If the switch is open, then the ac signal wont pass. If the switch is closed, then the ac signal will pass through the switch.AnswerIt is incorrect to say that an inductor 'does not allow' the passage of an alternating current. An a.c. current will pass through an inductor, although the inductor will limit the value of that current due to the inductor's inductive reactance. Inductive reactance, which is expressed in ohms, is directly-proportional to the inductance of the inductor and to the frequency of the supply. The value of the current is determined by dividing the supply voltage by the inductive reactance of the inductor.If the switch is connected in parallel with the inductor, then closing the switch will apply a direct short circuit across the inductor, and the resulting short-circuit current will cause the circuit's protective device (fuse or circuit breaker) to operate.


When an inductor and resistor are connected in parallel by how many degrees is the current flow through the resistor out of phase with the current flow through the inductor?

When a resistor and an inductor are both connected to an AC supply, the current in the resistor is in phase with the voltage, while the current in the inductor is a quarter-cycle (90 degrees) behind. Supposing they both draw 1 amp on a 12-volt AC supply. The resistor will dissipate 12 watts, while the inductor will dissipate no power. Any power that enters the inductor comes back to the generator in a later part of the cycle. But the current drawn from the supply is 1.414 amps, so this would be a load with a power factor of 0.707.


Does inductor allow ac to pass through it?

Yes, with some difficulty. You can think of an inductor as a kind of "AC resistor"in a way. The higher the frequency of the AC, the more difficulty it has passingthrough the inductor.If you apply AC voltage across an inductor, whereV = voltage of the ACf = frequency of the ACL = inductance of the inductor,then the AC current through the inductor isI = V/2 pi f L


Can we use a DC source with an inductor?

Yes, an inductor allows DC to pass through it. An inductor resists a change in current, proportional to inductance and voltage. At equilibirum, an ideal inductor has zero impedance. The differential equation for an inductor is di/dt = v / l


How dc supply is applied to field coil in a brush less alternator?

Through a coupled inductor, similar to a transformer, but working on DC instead of AC.


What type of inductor is installed in a circuit to impede the flow of ac of a frequency?

A: The inductor is called a RF choke


What is the phase difference between the current through the resistor and inductor in an AC circuit?

The phase difference between the current through the resistor and inductor in an AC circuit is 90 degrees.


What is the significance of using inductor in ac circuit?

Current filtering


Why a inductor is used in series before diode instead of resistor?

An inductor will supply better current source.


Why does an inductor block AC but allow DC?

An inductor blocks AC while allowing DC because it resists a change in current. The equation of an inductor is ...di/dt = V/L... meaning that the rate of change of current is proportional to voltage and inversely proportional to inductance.If you apply DC across an inductor, it will stabilize to some current flow based on the maximum current available from the current / voltage source. In this mode, the inductor presents very low resistance, so it can be said that it allows DC to pass.If, however, you apply AC across an inductor, you need to consider its inductive reactance by integrating the above equation in terms of the circuit conditions. The equation for inductive reactance is ...XL = 2 pi F L... meaning that the inductive reactance is proportional to the frequency and to the inductance.Thus, the higher the frequency, the higher the reactance. Since reactance is a phasor measure of resistance, it can be thus said that an inductor will block AC.


Why inductor block ac and pass dc?

When your circuit starts up, your inductor creates an electrical current in the opposite direction. With dc, this effect vanished after the circuit is started. With ac, the current keeps starting and stopping so the inductor keeps creating a current in the opposite direction.