The type of connector is used by the analog modems is RJ11 or RJ45.
The RJ11 Jack, also known as a Registered jack, is used to connect electronic equipment to a local telecommunications service. The RJ11 jack is usually plugged into a six-pin 6P6C jack.
RJ45 is used with ethernet cables in computer networking while RJ11 is used in connecting telephone units.RJ45 contains more wires than RJ11and RJ45 is physically bigger than RJ11 to accommodate the extra wires
"RJ11"
RJ11 Cable
rj11 cable is usually used for a phone line so for computers this particular cable can be used to connect to a dial up connection or dsl connection
RJ11
No, a conversion can not be made due to the different size of cables that each terminal end uses. An RJ45 uses a Cat , 8 wire cable where as a RJ11 uses a smaller 4 wire cable. The sockets for the RJ45 will be too wide to allow a RJ11 connector to securely connect to it.
RJ45 is a 8 pin connector used on networking(ethernet) cables RJ11 is 6 pin connector used on telephone cables in the USA
now currently use for rj 45
rj11
terminate the RJ11 end and on the RJ45 end crimp the 4 wires in the 4 middle slots. run the wires straight through, no crossover