No, a conversion can not be made due to the different size of cables that each terminal end uses. An RJ45 uses a Cat , 8 wire cable where as a RJ11 uses a smaller 4 wire cable. The sockets for the RJ45 will be too wide to allow a RJ11 connector to securely connect to it.
The simple answer is that there aren't enough wires; RJ11 has 4 wires, and RJ-45 uses 8 wires. In addition, the RJ11 wire is not twisted, so there is a problem with crosstalk.
rj11 cable is usually used for a phone line so for computers this particular cable can be used to connect to a dial up connection or dsl connection
The typical RJ45 connections for pins 1-8 are as follows: 1white/orange, 2orange, 3white/green, 4blue, 5white/blue, 6green, 7whitebrown, 8brown. The only twisted pairs actually needed for network access are the transmit and recieve pairs. These are your oranges and greens. So really all you need are two pairs for pins 1,2,3, and 6. Hope this helps.
If you are talking about a coaxial wire. It has a much larger diameter for the main conductor. This creates less signal loss so long runs will have more decibels at the end of the run.
RJ45 Modular connector can be bought at many different electronic stores in the neighborhood such as Radio Shack or Best Buy. Purchasing online can save you some money so be sure to check out ebay or amazon online stores.
According balanced equation ,3 mols are needed. So 3mol shoul be mixed
its so simple...connect them to the RJ45 port of the router and see that the port blinks.this indicates that they r up and running
It was dirty so they needed to disinfect the toilet.It was dirty so they needed to disinfect the toilet.It was dirty so they needed to disinfect the toilet.It was dirty so they needed to disinfect the toilet.It was dirty so they needed to disinfect the toilet.It was dirty so they needed to disinfect the toilet.It was dirty so they needed to disinfect the toilet.It was dirty so they needed to disinfect the toilet.It was dirty so they needed to disinfect the toilet.It was dirty so they needed to disinfect the toilet.It was dirty so they needed to disinfect the toilet.
It would depend on how fast you wanted it to move, there is a formula for this, and also pounds is a type of mass not force, so you would have to convert
He was a difficult individual so he needed special attention.He was a difficult individual so he needed special attention.He was a difficult individual so he needed special attention.He was a difficult individual so he needed special attention.He was a difficult individual so he needed special attention.He was a difficult individual so he needed special attention.He was a difficult individual so he needed special attention.He was a difficult individual so he needed special attention.He was a difficult individual so he needed special attention.He was a difficult individual so he needed special attention.He was a difficult individual so he needed special attention.
Going from USB to RJ45, at bare minimum, requires a USB device controller and a compatible network controller with compiled software drivers. The kits you see in stores are more than just a few wires, they are an external network card. Building one yourself will be much more time consuming and expensive than just buying one off of the shelf.
Voltage is electrical pressure and Joules is a power rating so other info is needed