If you are talking about a coaxial wire. It has a much larger diameter for the main conductor. This creates less signal loss so long runs will have more decibels at the end of the run.
An RJ11 cable connects a telephone to a telephone jack, which provides the telephone with a dial tone.
rj11 cable is usually used for a phone line so for computers this particular cable can be used to connect to a dial up connection or dsl connection
RJ11 Cable
for internet cable it is called RJ11 and for the intranet cable it is called RJ45
No, a conversion can not be made due to the different size of cables that each terminal end uses. An RJ45 uses a Cat , 8 wire cable where as a RJ11 uses a smaller 4 wire cable. The sockets for the RJ45 will be too wide to allow a RJ11 connector to securely connect to it.
terminate the RJ11 end and on the RJ45 end crimp the 4 wires in the 4 middle slots. run the wires straight through, no crossover
RJ45 is a 8 pin connector used on networking(ethernet) cables RJ11 is 6 pin connector used on telephone cables in the USA
RJ11 and RJ45 are the names for the terminators at the ends of the cables. RJ11 is the 2 pair (4 wire) terminator used for telephones. RJ45 is the 4 pair (8 wire) terminator used for ethernet cable.
Depends on the standard being used, but it will either be an: RJ11 or RJ45 connection jack.
The type of connector is used by the analog modems is RJ11 or RJ45.
rj45 which is the large one but bt use rj11 whichis smaller
An RJ45 connector and a PCI NIC card are 2 completely different things. An RJ45 (Technically an 8P8C) is the connector at the end of a CAT cable which plugs into a NIC card. Unless you are thinking RJ11, which has nothing to do with CAT cables. An RJ11 is the name of the cable used for single-line dialup modems and telephones, in which case, the connector is called a 6P4C connector.
The RJ11 Jack, also known as a Registered jack, is used to connect electronic equipment to a local telecommunications service. The RJ11 jack is usually plugged into a six-pin 6P6C jack.