Because to actuate the brake you pull at the brake lever.
You can remove the parking brake lever, from the brake shoe on your Chevrolet Cavalier, by removing the retaining clip. The retaining clip connects the brake lever cable to the brake shoe.
The brake light switch will be located somewhere on the brake pedal lever or at the place where the lever connects to the dash brace.
A small release lever just in front of the parking brake foot lever
There should be a lever down by the brake pedal. it will look kind of like a gear with a tab on it. that lever releases the parking brake. just be careful not to let the parking brake pedal smack you in the face....
To replace a break lever on your bike, you must first remove the old brake lever, located on the handlebar. This may require you to temporarily remove the gripper and the gear shifter, allowing you easy access to the brake lever. After loosening the hex bolt that attaches the brake lever to the handlebar, the lever should slide right off. You will then want to remove the brake cable and the cable housing from the lever. Put the new brake level onto the handlebar, being sure to match it to the one on the other side. Tighten the lever with the hex bolt, and reattach the cable housing to the lever. Test the brake to make sure it is satisfactory, making adjustments as needed, and then reattach the gear shifter and gripper.
on your brake pedal lever.
look on the brake pedal lever.
The Parking Brake
on your brake pedal lever.
on the brake pedal lever.
Either the brake line is snapped or, if it's a lever e-brake, the nut is loose inside the lever box. Your rear brakes may also need to be replaced or adjusted.