One will find that there is no slang term for brake lines, as they are not referred to in another way. There are many other slang terms for street etiquette, but there is not a slang therm for 'brake line' currently.
Replace the brake line, bleed the brake. top up with brake fluid. Done.
When a brake line is leaking on the Chevy Venture the brake line should be replaced as soon as possible. A leak, however small, can cause hydraulic fluid to escape the brake line which will cause a loss in brake pressure. The brakes should be bled of air after the new line is put in to remove gaps in brake pedal pressure.
depends where the leak is. In the brake line or at the pump? electric or mech brakes? if its in the line you should be able to replace the line section
Air in the brake lines. Severly worn break pads. Worn brake boost piston. Cracked brake line on that brake. Loose brake line.
measure affected line
To fix a clogged brake line, first find the clog. Then, remove the clogged line from the cylinder. Attach a new line, and pump the car's brake to test it before driving.
The 1999 Dodge intrepid brake lines schematics diagram shows the routing of each brake line. The diagram will show the brake line routing from the master cylinder to each wheel.
replace brake line the damage to the line or if the jb weld gets into the line it will affect how the system works.
You can cutoff the rear brake line. You will no longer have rear brakes and the fluid will leak out. It is not recommended that can't off the rear brake line, without replacing it.
The cost of brake line repair is anywhere from 50.00 dollars and up. To repair the brake line it depends on who is fixing the car and what type of car you have.
I'm pretty sure the brake line is 3/16" and the fuel line is 1/4". I'm doing a complete brake line replacement on my 01 Z24 right now.
Disconnect brake line at the nearest junction Disconnect brake line at the affected wheel cylinder Route new brake line same way old one was Connect both ends Bleed the wheel cylinder on that line MAKE SURE MASTER CYLINDER DOES NOT RUN EMPTY