answersLogoWhite

0

You can cutoff the rear brake line. You will no longer have rear brakes and the fluid will leak out. It is not recommended that can't off the rear brake line, without replacing it.

User Avatar

Wiki User

11y ago

What else can I help you with?

Continue Learning about Music & Radio

2000 Chrysler 300m rear right tail lights do not work but those same bulbs do work when the brake pedal is pressed What is the problem?

My Brake tail Lights Stay on when my car is complete turned off and my lights are off to.


Brake lights do not work on my 1994 Jeep Cherokee bulbs and fueses are ok could it be the brake light switch?

Nonworking Brake LightsYes, it could be the brake light switch [either not properly adjusted, or defective], BUT there could be other causes:One of the several connector plugs in the brake light wiring could be disconnected.Any on of the conductors [wires] in the brake light circuit could be cut, broken, or disconnectedA ground wire could be cut, broken, or disconnected.At any one of the above connections, there could be a buildup of corrosion which cuts off the flow of electricity.There could be other causes which do not come to my mind at the moment.


Why would the rear running lights stay on after your Honda Civic 2000 is off and it's not the light switch?

What do you mean by running lights?? If it is the brake lights you are talking about, it may be the brake switch. this switch is on the brake pedal and makes the lightrs come on when you press the pedal. if you look to the very top of your brake pedal you should see this switch and a wire connected to it.(You may have to remove some of the trim, you may not. Im not to sure on this year. Hope this helps you some.


Should you drive with a rear differential leak?

Only off a cliff; if your differential siezes your rear end falls off a millisecond later.


Where do you cut off a scorpions stinger?

If you cut of your scorpions stinger it might die, but if you dont cut it to far down it will be fine. (If you cut it to far in the tail your scorpion will bleed to death) So be careful or go to a pet store and ask someone to do it for you.

Related Questions

Which slot on the rear brake cover to Manually back off brake shoe adjustment to remove a stuck brake drum off of a 1997 dodge caravan?

It is the slot up top, just below the brake line.


Does fuel cut off cause brake lock or brake lock cause fuel cut off?

Neither.


How do you replace a rear brake line on a 1992 Chevy Corsica?

take the old one off, put a new one on.


How do you replace rear brake line on a 1969 camaro?

just unscrew it at the fittings and take it off and take it to the parts store with you and get another line at the parts store and bend and reinstall.


How do you get brake pads off a 2003 Yukon Denali?

how to get rear brake pads off 2003 Yukon denail


How do you install a wheel cylinder on a 1998 dodge grand caravan?

Rear wheel? Remove wheel Remove brake drum Loosen and remove brake line to wheel cylinder Remove mounting bolts at rear of wheel cylinder Pry brake shoes back from wheel cylinder Pull wheel cylinder off backing plate Install in reverse procedure Bleed affected brake line


How do you Change rear brake pads on a Yamaha YFZ 450?

You need to go to the rear brake caliber on the rear of your quad and take that off then you need to take off the two Allankeys on the side of your caliper


What causes an engine to cut off when you press the brake?

Usually a vacuum leak, check your power brake booster hose first, then any other vacuum line for cracks, breaks, or disconnection.


Remove the rear brake calipers on a 2009 Dodge Journey?

To remove the rear brake calipers on a 2009 Dodge Journey, start by safely lifting the vehicle and removing the rear wheels. Next, locate the caliper mounting bolts on the back of the caliper and use a socket wrench to remove them. Carefully slide the caliper off the brake rotor, supporting it to avoid putting stress on the brake line. Finally, secure the caliper with a bungee cord or similar to prevent it from hanging by the brake line while you work.


How do you remove the rear brake calipers from a 1987 Celica gt?

To remove the rear brake calipers from a 1987 Celica GT, first, ensure the vehicle is safely lifted and secured on jack stands. Remove the wheel to access the caliper, then detach the caliper by unbolting the two mounting bolts located on the rear of the caliper. Additionally, remove the brake line or the retaining clips, if necessary, to completely free the caliper from the brake rotor. Finally, slide the caliper off the rotor and set it aside, taking care not to damage the brake line.


How do you remove the rear brake drum off of a Honda TRX300FW?

id like to know the same thing. i have a 1995 Honda ATV. and i cant get the rear brake drum off


What is the rubber hose on rear brake line splitter block used for?

The flex line is used in place of steel tubing because of housing movement up and down a rigid line would either break off or kink and shut off flow.