Cadillac DeVille

What is the brake rotor specification for a 1995 cadillac deville?

202122

Top Answer
User Avatar
Wiki User
2006-10-02 00:32:39
2006-10-02 00:32:39

front min spec is 30.08mm rear min spec is9mm

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

It's a non-vented disc. Should be easily available at any auto parts store.

User Avatar

1-8-4-3-6-5-7-2 Rotor turns counterclockwise.

User Avatar

The brake rotor functions similar to the breaks on a bicycle. Each brake rotor contains a rotor and a brake pad. When the brake is applied, the brake pads squeeze the rotor, causing the wheels to stop.

User Avatar

1-8-4-3-6-5-7-2 Rotor turns counterclockwise.

User Avatar

Warped brake rotor.Warped brake rotor.

User Avatar

No it is not necessary to remove the axle nut in order to remove the front caliper. Once you remove the caliper the rotor should come off.

User Avatar

Remove wheel Remove caliper mounting bolts Slide caliper off rotor Rotor should slide off hub Remove wheel Remove caliper mounting bolts Slide caliper off rotor Rotor should slide off hub

User Avatar

1 - 8 - 4 - 3 - 6 - 5 - 7 - 2 The distributor rotor turns COUNTERCLOCKWISE

User Avatar

A brake rotor is what your brake pads squeeze to slow your car down. The brake pads are mounted in a caliper. When you apply the brakes, the caliper pushes the brakes into the rotor, which then slows down your wheel.Hi, It is a brake rotor, and is the physical disc of a disc brake. Peace, crigbyThe brake rotor is the disk part. Should be shiny from where the brake pads have been rubbing on it.

User Avatar

The rotor is the disc in the disc brake system.

User Avatar

Rear is to the back of the vehicle. Brake rotor is the rotating part of a disc brake.

User Avatar

first measure the brake rotor then inspect the rotor surface inspect the brake pad surface if either is rough or irregular then replace the rotor you will have better brake performance and brake pad -rotor life thank you

User Avatar

Jack up the front of your 1991 Mitsubishi Eclipse. Remove the brake pad assembly. Loosen the brake rotor by tapping on it with a hammer or mallet. Slide the brake rotor off. Reverse the process to install the new brake rotor.

User Avatar

You remove the brake caliper frame and rotor is then loose.

User Avatar

Remove the tire and wheel from your 1995 Chevy. Remove the brake assembly. Tap on the brake rotor with a mallet or hammer. The brake rotor will slide off.

User Avatar

cant remember for sure but its either 15 or 18 mill. there definitely metric

User Avatar

2005 Toyota tacoma how to remove the brake rotor

User Avatar

The brake spindle goes through the center of the rotor. You will see it when rotor is removed.

User Avatar

The brake caliper should not touch a rotor ever. There is a metal backing plate on the brake pad that can rub the rotor if the pad wears thin enough.

User Avatar

The 2001 Pontiac Grand Am minimum brake rotor thickness is .075. The minimum brake rotor thickness is a standard minimum. Certified mechanics cannot use the brake rotor when the thickness drops below this level.

User Avatar

I believe you need to turn a rotor or both rotors. They probably were not turned on your brake job It is cheaper to just replace the rotor than to have it turned, I have found this is a typical problem on the Catera

User Avatar

A brake caliper will squeeze your brake pads in your car against the brake rotor surface allowing it to stop or slow your vehicle down. The brake caliper is clamped on the rotor.

User Avatar

If you are wondering how much brake rotor replacement is going to cost because your car needs a new brake rotor, then the answer is around 200-400 dollars.

User Avatar

Remove the wheel and tire assembly and the brake caliper then the brake rotor will slide right off.

User Avatar

cheap;, no heat dissipation,worn out rotors brake cylinder collapsed into the rotor


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.