0
multiply the diameter of the bar by 40 its a thumb rule for compression member
and for tension member it could be 70 *diameter of the bar calculation is shown in code book
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How much steel reinforcement used 1KN?
The steel reinforcement used will depend on several factors. Column length, beam length, and the column and beam cross section all depend on how much steel will be needed.
What is the maximum overlap of steel rods in reinforced concrete sections?
Steel reinforcing rods have minimum overlap requirements to ensure that the reinforcing has a continuous effect throughout the structure.In some instances this minimum overlap is 600mm, but the requirement does vary and must be confirmed by an Engineer for each particular design.Maximum overlaps would be used to ensure wastage is reduced, and to ensure adequate concrete cover.
What circumstances combined footing is required?
where there the two columns faces overlap each other, when the column face is near to the boundary line
How much loss is considered during gas cutting work for mild steel plate?
Gas cutting & burning loss calculation chart required for mild steel plate?
Will a w8x24 steel beam span 16 feet with a live load of 50lbs psf?
Possibly, but you haven't mentioned thickness of the steel -8 x 24 is not enough info for that calculation.
How do you calculate the self-weight of a column?
self weight calculation of column
What happens when you double click a right column border?
It uses Autofit to widen the column to the widest value in the column, so that it can be seen without appearing to overlap into a new cell beside it.
How much steel reinforcement used 1KN?
The steel reinforcement used will depend on several factors. Column length, beam length, and the column and beam cross section all depend on how much steel will be needed.
What is method of curtailment of steel bars in RCC column in multi storeyed building?
column curtailment details
Formula for weight calculation of solid steel bar?
d*d/162
A Grout used in the baseplate of structural steel column?
Yes.
What is lap length of bars?
Over lap of steel bar is provided 60 times of dia of steel bar. For example (.5") dia steel bar overlap length is (30"). (.5x60=30")
Square meters in one ton of structural steel?
It is roughly 7.6m2 per ton of steel structure material. This can be used for approximate calculation.
What is the maximum overlap of steel rods in reinforced concrete sections?
Steel reinforcing rods have minimum overlap requirements to ensure that the reinforcing has a continuous effect throughout the structure.In some instances this minimum overlap is 600mm, but the requirement does vary and must be confirmed by an Engineer for each particular design.Maximum overlaps would be used to ensure wastage is reduced, and to ensure adequate concrete cover.
What circumstances combined footing is required?
where there the two columns faces overlap each other, when the column face is near to the boundary line
What is lap Length of steel Bars?
Over lap of steel bar is provided 60 times of dia of steel bar. For example (.5") dia steel bar overlap length is (30"). (.5x60=30")
What is the formula to calculate the yield moment for a column?
My= As*Fy*Jd As= Area of steel reinforcement (tensile steel only) Fy= yield strength of steel Jd= moment arm
