Want this question answered?
the power steering reservoir is located next to coolant expansion tank in the engine compartment.
The ENGINE coolant reservoir is on the drivers side of the engine compartment next to the firewall
On a 2000 Lincoln LS : The thread on cap on the engine coolant reservoir is the pressure cap / radiator cap * the engine coolant reservoir is in the engine compartment , on the drivers side of the engine compartment , next to the firewall , you can see the cap through a hole in the " trim "
the fuse box is located in the glove compart ment on the lft side. the main fuse box is located under the hood on the passaenger side next tho the coolant reservoir
What type of coolant sensor? The below answer is for the coolant LEVEL sensor. The coolant TEMPERATURE sensor on my vehicle is located just next to the thermostat housing. On the front top center area of the engine just behind the radiator. Follow the coolant hoses if you have trouble. On my 1995 Jeep Grand Cherokee the sensor is located on the top of the plastic coolant reservoir tank. Look for a small (2-wire?) electrical connector.
The coolant temp sensor is located next the the thermostat housing.
If the reservoir has a hose that travels to the top of the radiator, then it is filled with engine coolant. If the hose is not connected to the radiator, then it is most likely a windshield washer bottle.
in the engine compartment next to the coolant reservoir along with it's 60amp fuse
Open the hood and the Coolant reservoir on the '92 Previa is next to oil reservoir on the left side. Unscrew radiator cap from the coolant reservoir, add the 50/50 mix of coolant fluid into the reservoir. (Recommend use Prestone extended life coolant) Fill the coolant into the reservoir, it take about 3 gallon, and be sure that the coolant is pass the full mark of the reservoir. Now, turn on the car, during the engine running (about 10 minutes) kept check the level of coolant be sure it still maintains pass the full mark level. Screw back the radiator cap to coolant reservoir. Run engine for another 30 minute. This will ensure that thermostat is open and and ensure the fluid is circular all around of the radiator and hoses. Waite engine cool down, then open the radiator cap and check the coolant fluid level. If the level is low then add more coolant. Do not fill the coolant pass the full Mark's point. If the coolant fluid is still the same as in full mark then it is good. Continue to check the coolant fluid for next couple day. Besure that it is at the full level mark.
To add coolant to and 1985 Mercedes 380se find the reservoir located in the engine bay next to the radiator. Make sure to use the proper mixture of coolant to water ratio and pour until the appropriate level. Overfilling can lead to sprouting a leak while the engine is running.
I was looking at a picture in the 2004 Lincoln LS owners manual and it shows that the engine coolant reservoir is located on the drivers side of the engine compartment next to the firewall ( you can see the cap for the reservoir through a hole in some kind of panel )
Next to the coolant reservoir... black hose sticking forward with a plastic screw in it...