Want this question answered?
recerved capacity
No, it does not have enough capacity (i.e. ah rating).
transformer action doesn't depend on power factor that is why we indicate its rating in KVA
yes, old and new battery should have same voltage rating. Battery type shud match only capacity may be large.
Auto batteries today, for the most part, are 12 Volt. They are rated according to cold cranking amps or what is commonly called CCA. CCA is the amount of current, measured in amps, that a battery can crank out for 30 seconds at 0°F. This rating is important as a battery has to work harder to start your engine in cold temperatures. The higher the CCA rating, the more power the battery can deliver. Be sure and purchased a battery with the highest possible CCA if you live in a cold climate. Never buy a battery with a CCA rating lower than the one that came on your vehicle. Batteries are also rated in reserve capacity or RC. Reserve capacity is the length of time the battery can provide 25 Amps at 80°F. The reserve capacity is important if your alternator ever fails and you have to drive on the batteries reserve capacity.
First the amperage of the 1500 watt device has to be established. I = W/E. Amps = Watts /Volts = 1500/24 = 62.5 amps. To answer this question the amp/hour rating of the 24 volt battery has to be stated. This is the capacity rating of the battery. Take that rating and divide it by 62.5 amps will give you the amount of hours that the battery will take before it drains and needs to be recharged.
The rating of "4600 mAh" is one description of the battery's capacity. It doesn't tell you anything about the delivery or discharge rate of the battery. Those depend on the external circuit that you have connected to the battery. For example, if nothing is connected to the battery's terminaks, then the battery is giving zero amperes.
What type of boat must have a capacity plate
Yes, the amp hour rating gives you an idea of the capacity of the battery and charger. The charger and battery need to have the same voltages. i.e. dont try to charge a 6v battery with a 12 v charger. The battery will be charged until it is full.
If your load runs on 6 volts, you cannot replace it with a 12 volt battery. You will be exceeding the voltage rating of your load and will start a fire.If you want more amps (capacity) then you can wire more 6 volt batteries in parallel with the first.
mAH stands for milliamp-hours. It is a measure of the power capacity of a battery. If a battery has a mAH rating of, say, 480mAH, it means the battery can supply 480 milliamps for one hour, or 960 milliamps for a half-hour, or 240 milliamps for two hours, etc.
mAH stands for milliamp-hours. It is a measure of the power capacity of a battery. If a battery has a mAH rating of, say, 480mAH, it means the battery can supply 480 milliamps for one hour, or 960 milliamps for a half-hour, or 240 milliamps for two hours, etc.