dome light switch is bad. these are in the body. open the door, and look down on the lower rear corner. there will be a rubber boot cover. they are a bit cranky to change, because the wire doesnt have much slack
low on oil oil pressure switch is fubar oil pump is dying, and soon the engine will follow
You have to fix the cause of the code that turned the light on. It can than be reset with a scan tool.You have to fix the cause of the code that turned the light on. It can than be reset with a scan tool.
UV light can be turned into infrared light u dofus. DANJUIN
With a scan tool after repairing the cause of the code that turned it on.With a scan tool after repairing the cause of the code that turned it on.
The light can not be reset without fixing the cause of the code that turned the light on.
Fix the cause of the code that turned the light on.
The cause of the code that turned the light on will have to be repaired before the light will turn off.
Be sure the dome light switch is not turned on manually.
Have you repaired the problem that cause the light to come on in the first place? If not the light will just come back on. You reset the light with an OBD2 scan tool.
You need to repair the cause of the code that turned the light on. You can then reset the light with a scan tool or a battery disconnect.
Reset the change oil light on Mazda 3
A flashing check engine light is usually due to a misfire. see related questions below.