What characteristics are you looking for? At full load, a synchronous generator will be spinning at synchronous speed, providing real power (watts), and likely some reactive power (vars), or it may be taking reactive power from the system to help hold the system voltage down under light loading conditions.
Full load amps for a three phase, 375KVA generator is 375 / (voltage in kV) / sqrt(3).
The volatge regaulation be calculated by calculating the percentage difference between volatge at no load and voltage at full load
A generator, rated at 16 MW, should be able to continuously supply a load of 16 MW. You don't need to compute its 'minimum load', because the minimum load will be zero watts! In other words, you can run the generator with no load whatsoever if you wish to waste fuel.The point is that the power supplied by a generator is determined by the load, NOT by the generator itself -so it is important that the generator is capable of supplying the maximum load applied to it. A generator's 'rated power output' simply tells us the maximum load it is capable of supplying.
304 Amperes
The Perkins 100 KVA generator uses approximately 23.8 Liters per hour. The Perkins KVA generator can be purchased at any Perkins licensed dealer.
Full load amps for a three phase, 375KVA generator is 375 / (voltage in kV) / sqrt(3).
The open-circuit characheristics and the load characheristics
Load rejection occurs when load is suddenly removed from the generator. The most obvious example of this is the breaker connecting the generator to the power grid opens. This results in a full load rejection. Load pick up means the generator is supplying power to a given load. When a generator comes on line, it will pick up some load that might have been supplied by another generator.
35 kV.A.
load test on dc shunt generator is a test to plot the internal and external characteristics of the generator.
8
Actually this question can not be answered since the actual time mainly depends on the load attached to the generator. If running idle (i.e. no electrical load connected) it will run significantly longer than with full load connected.
6.3 liters/hour at full load
The load conductor is connected to the load side of the generator breaker. Once the generator is up to speed the load breaker is closed and the voltage is then applied to the load.
The volatge regaulation be calculated by calculating the percentage difference between volatge at no load and voltage at full load
It depends on the total connected load (KW) of the house. If the total connected load is about 20 KW the alternator generator should be designed to meet peak 20 kw load
1.5litres/hr full load at 40% efficiency