Want this question answered?
To answer this question the voltage of the bulbs is needed.
I don't know if you are trying to ask if you can run a 240V panel off a GFCI or run a 120 V sub panel off of a GFCI. Can you clarify please,,,Thanks
Both are giving the data about storage capacity of a battery. For Ex. 12V 7AH Battery will run 7 hours if you are driving the load of 1Amp continuously. But 12 12AH Battery will run 12 hours if you are driving the load of 1Amp continuously.
Junction box for what? Do you mean a sub panel?
12w at 12v = 1amp 3/12=0.25 0.25amp = 250ma 2.5ah= 2.5amps per hour 2.5/0.25=10 A 3w led at 12v 2.5ah battery will last 10 hours.
No. The ignition needs 12v to run, the starter needs 12v to crank, the bulbs all need 12v to get bright enough...
A 60VA transformer can run only one 50W bulb.
More than likely, your 240V system has branches that supply a standard household 120V to things like lighting outlets. Most light bulbs in the US run on 120V so this is probably a convenience feature. Otherwise you would have to go to a specialty store and buy 240V bulbs.
No. Car stereos run on 12v DC power. A wall outlet, depending on where in the world you are, gives out either 110-120 or 220-240v AC power.
No.
no
No, the supplies output is too small. To run a 550mA device a supply source of 600mA and larger would be needed.
Yes, because you will be able to maintain current flow between phases.
Actually, I have seen this in a respected electronics magazine (Elektor) quite some time ago: A diode (selected to be capable to handle the amps, the voltage and the heat from the bulb - if placed inside the lighting fixture) is used to "cut off" one half of the AC sine wave and thus sending pulses of 120V to an incandescent light bulb, simulating a simple dimming device. The proposal was meant to run 240V bulbs at 50% of their brightness but I am pretty certain this concept can be used to run 120V bulbs from 240V power. One other way of connecting 120V bulbs to 240V would be to connect two 120V bulbs OF THE SAME WATTAGE in SERIES, so the two bulbs form their own voltage divider. Not sure what happens if one bulb burns out - I would expect the other one to blow too, as a dying light bulb represents zero Ohms (plasma/arcing) for a few milliseconds before it goes dark forever.
2
You can hook up a battery and 240v 12v heavy duty charger system,that is the easiest way to get over that problem. The charger has to deliver enough amperage to cover the load from the winch.RegardsJohn Cas
No you can only have one dryer on a 240v circuit and nothing else can be attached to it either considering your using a 240v electric dryer