ATS (automatic transfer switch) is the device than can transfer normal power to emergency power automatically when the normal power is off. Usually, It can recover the normal power supply quickly after normal power is on.
That is, using ATS, you can supply the load with double power, one is normal power and another is emergency power.
Therefore, we may get the result that ATS should including several important components like monitoring device, main breaker, bypass breaker and automatic action mechanism.
Like any Automatic Transfer Switch, wiring ATS not easy and not difficult. It requires a qualified electrician to wire it properly. You can read more about wiring an Automatic Transfer Switch in the related link.
An automatic transfer switch would be used when one needs to switch energy from one source to another and cannot do it manually. It can be used to switch from electric to a generator when needed.
A transfer switch, in general, switches load between two sources. An automatic transfer switch or ATS is usually installed where a generator is located to allow the generator to give power while electricity is out.
ATF (Automatic Transmission Fluid)
Yes you can as long as the sensing coils of the transfer switch are the same as the 100 amp service. The transfer switch has to be able to tell when the voltage is back from the utility side of the switch when the power is restored.
Yes it can. Things to consider would be the fuel source, how to safely deal with the exhaust, and the transfer switch. I would recommend an automatic transfer switch.
It is mounted to the back of the breaker panel that is below the refrigerator.
This circuitry is already in the market place. It is in the form of an ATS (automatic transfer switch). The controller is pre programmed for sensing and switching. Customer input is limited to setting of the timing of the relays in the transfer switch.
In conduit? direct burial? distance?
If it is an automatic it will not have a clutch safety switch it will have a neutral safety switch
There are a few different types of low voltage transfer switches available, including manual transfer switches, automatic transfer switches (ATS), and generator transfer switches. Manual transfer switches require the user to manually switch between power sources, while ATSs can automatically detect and switch to an alternate power source. Generator transfer switches are specifically designed for use with generators and will automatically detect when a generator is running and switch the load to that source of power.
How to transfer an elevation with an automatic level