The terminal strip's rating is 15 amps at 600 volts. It does not matter what the voltage is up to 600 volts, the maximum amperage allowed on the strip is 15 amps. It could be 15 amps at 12 volts or 15 amps at 600 volts or any voltage in between.
The voltage for the air compressor is needs to come from a double (two) pole breaker. The size of the breaker needs to be 250% of the full load amps of the compressor. The wire size to the compressor has to be 125% of the full load amps of the compressor.
Do you have a dual capacitor that starts both the compressor and the fan motor? You need 230V to power the compressor. You should have one wire from the capacitor going from the start terminal on the compressor and one going from the common terminal to common on the capacitor.
In order for this question to be answered properly, you need to provide more info such as what size is the compressor 9ie the amperage and voltage rating).
that meter call AVO meter or digital clamp meter
Compressor locked rotor amps are measured with an amp-probe or clip on ampmeter. Lock rotor amps are amps with the rotor not turning/moving, and the winding at ambient temperature. locked rotor amps are X4.5 to X5 times the FLA of motor name plate.
Borrow a clamp on amp meter and check full load amps. If pulling full load amps then compressor condemned.
csr
Rated load amps = rla
amprobe
The terminal strip's rating is 15 amps at 600 volts. It does not matter what the voltage is up to 600 volts, the maximum amperage allowed on the strip is 15 amps. It could be 15 amps at 12 volts or 15 amps at 600 volts or any voltage in between.
your condensor is clogged up, or your condensor fanmotor is not working, or your compressor struckup due mechanical problem inside of your compressor.
The voltage for the air compressor is needs to come from a double (two) pole breaker. The size of the breaker needs to be 250% of the full load amps of the compressor. The wire size to the compressor has to be 125% of the full load amps of the compressor.
17amps
Common Start Run
C = Common S = Start R = Run
To test a compressor if locked up read the tag on compressor for locked rotor amps, then bypass safety therm-o-switch found under protective black cover on compressor, and with a clamp-on amp meter momentarily run compressor to check amperage.