This type of question refers to the gravity type fed hot water heater and the correct level is just below the overflow pipe, however it is personal preference.
Drain it to the correct level so its good
there are two water level indicators usually mounted in front of boiler to ascertain the level of water inside the boiler am explain construction and working on next page
Effect of low water level in the boiler is rapid increase the temperature of the metal tubes, causing a collapse or rupture.
there are two water level indicators usually mounted in front of boiler to ascertain the level of water inside the boiler am explain construction and working on next page
Effect of low water level in the boiler is rapid increase the temperature of the metal tubes, causing a collapse or rupture.
Overheating of water wall tubes may cause crack. Boiler will damage due to boiler drum level goes down.
Water does not expand with heat the way hydrocarbons do. Thus, from an expansion perspective, the water level will not change as the temperature increases. *To correct the answer listed above without deleting it, as I'm new here :) : Water is one of the few elements that expands in its liquid and solid states. The overall expansion is approximately 4%. There are two basic types of boilers used for hydronic heating, water and steam. The level of water in a steam boiler will drop when fired; as the liquid water becomes a gas, less liquid remains in the boiler. Any water boiler used for heating will be constantly "full" as it is essentially a sealed system. Due to the expansion of the water when heated, all liquid water heating systems use expansion tanks to account for this change in volume. correcting the answers listed above without deleting them Initially when a boiler is fired the water is heated and the steam starts to generate. During this time large amount of ebolution is taking place as the steam is trying to rise up through the water. This causes a swell in the water level and we actually sea a rise in the water level. when fired always waterlevel surges,it is seen practically
Boiler blowdown is required to prevent corrosion by removing impurities that contribute to its formation in a steam boiler and to facilitate the generation of pure steam by preventing the carryover of impurities. Why Boiler Blowdown is Required? Proper blowdown procedures are necessary to maintain the solids content of the boiler water within specific limits and to quickly eliminate contaminants if the water becomes contaminated.
boiler drum diffferential pressure level calculation explained
3inces
The lower line indicates minimum water needed, the upper line indicates max.
NONE a boiler is a boiler and a water heater is a water heaterSEE ASME section IV or the NBBI