we can calculate the current in a commmon electrical circuit by this formulae i.e,I=V\R where i is the current flowing in the conductor, R is resistance , V is the voltage.. THE FORMULA IS CORRECT but the term conductor does not suffice an explanation since a conductor is low in resistance R= resistance not conduction.
To reduce % error, you may- 1. Take an average over many observations. 2. Use the correct bridge for various measurements of resistance.(see variants of the wheatstone bridge)
Do not add any unwanted device in the circuit. Have correct sized wire for the application and the load current.
series circuits have 1 pathway they have constant current(Amperes) not constant voltage. Resistance=R+R+R+...
Resistance is resistance , no matter if it is contact resistance or any other resistance. And formula is R = V / I.
Weight of the item being lifted.
Oppositional is the correct spelling.
.060
AC current tends to flow towards the surface of a conductor due to what is known as the skin effect. This phenomenon acts to reduce the effective cross-sectional area of a conductor and, therefore, elevate its resistance. This elevated value of resistance is known as AC resistance.The skin effect increases with frequency. At 50/60 Hz, the skin effect is quite moderate and, so, the AC resistance is not significantly higher than the true (or DC) resistance of the conductor.As to 'which value of resistance is correct?' Well, the natural resistance of a conductor is directly-proportional to its cross-sectional area and resistivity, and inversely-proportional to its length and the type of current plays no part in this. This is the value that a DC current would 'see', so you could say that this would be the 'correct' value of resistance.
Yes- you have suggested a correct working definition for a conductor.
All of these are correct.
From the French, it is "pièce de résistance", a showpiece, crowning point, or highlight.
coefficiant
Yes- you have suggested a correct working definition for a conductor.
You are correct. What exactly is your question?
BR9EG NGK(resistance type) is what the owners manual says to use
Refer to autozone.com . They have a comprehensive guide to the proper way to test and the correct resistance.