Actually it depends upon the type of dryer. So according to ur model no contact ur dryer dealer.
Yes heating element is burner assembly.
the heating element is gone out
where is the heating element on a kenmore series 400
It could be caused by a damaged heating element. You should have the heating element checked by a professional. Try cleaning the dryer first. Remove lint clogging the exhaust vent. Overheating in the washer might cause the heating element to shut off safely. Also check if the dryer is plugged correctly.
The heating element is on the bottom in the back, if you pull the front base panel off, you can look back and see the element against the back of the dryer. You can undo two screws and pull the element out. "MAKE SURE TO UNPLUG THE DRYER FIRST SO YOU DO NOT GET SHOCKED" Jeremy
The heating coil/element has probably gone out.
no this product has a built in heating element.
One thing that could be wrong with the dryer is a bad heating element.
There are two circuits in your dryer. One runs the motor, the other the heating element. Something in your heating element circuit is broken, and the most likely culprit is the element. To check it, unplug the dryer, take the back off, find the element, disconnect one of the two wires and put an ohmmeter across the two connections. If it reads infinity, change the element.
Electricity is changed to heat in the heating element and motion in the blower motor
Likely due to a lint accumulation on or near the heating element.
Your heating element is going out and that is why the fuse blew as well. You will need to have the heating element replaced in order for the dryer to work like it did when you bought it.