0
What else can I help you with?
How do you replace valve cover gaskets on a 1992 subaru legacy?
Do you still need some assistance?
How do you remove engine cover on subaru legacy?
ok
Where is the starter on a 1991 Subaru legacy?
Top, front, center, under the plastic cover.
Why you'd have oil under the spark plugs on a subaru?
Because your'e spark plug pipe gaskets and your'e valve (rocker) cover gaskets are shot! The swell your'e rubber boots cause misfires. Replace them all. Good for 40 or 50k. T Ray.
How do you replace valve cover gaskets on 5.4 2001 F150?
I'm going to replace the valve cover gaskets on my 5.4. The top bolts their very loose, but hesitant to come out. any thing would help me
How do you change valve cover gaskets on a 01 Cadillac catera?
cadillac catera replace valve cover gasket 1997
How do you replace the valve cover gasket on a 1995 subaru imprezna?
1. Take the bolts out 2. Take the valve cover off 3. Toss out the old gasket 4. Clean head mating surface 5. Install new gasket into clean valve cover 6. Put cover back into place 7. Replace bolt gaskets 8. Tighten to spec 9. Enjoy!
Replace valve cover gaskets on 1998 740i BMW?
Take to a qualified BMW mechanic.
Why is there oil in your spark plugs 99 Chevy caliver?
You need to replace the valve cover gaskets.
How do you fix a valve cover gasket leak on 02 grand vitara?
either tighten the valve cover bolts, or replace the gaskets.
How do you Replace a valve cover gaskets in 1996 buick regal custom?
remove motor mount "dog bones" and also label/remove spark plug wires from spark plugs, remove valve cover, clean cover from debris, use light coat of oil to stick gasket, replace round rubber gaskets, replace cover, wires and "dog bones"
How do you replace the valve cover gaskets on a 2003 Jeep Liberty?
To replace the valve cover gaskets on a 2003 Jeep Liberty, the valve cover is removed. The old gasket is then removed from both the valve cover and the manifold (old gasket will come off in pieces on both sides). Then spread the sealant on the manifold, place the new gasket on, then put sealant on top of the gasket and replace the valve cover and bolt down.
