0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How install sterring pinion gear on john deere l130?
I cant seem to get the new pinion gear to go on the drive shaft of my John Deere LA105. Is there a trick to it?
What oil do you use for LA105 John Deere?
at work we have serviced john deere equipment and we use 15 w 40. but your best bet would be to contact john deere themselves and give them the model and they should be able to tell you
Why does a John Deere LA105 mower engine rotate but not start?
Spark plug shot or gap not correct. Replace plug and if still doesn't work check and replace coil if bad. Check you tube for how to check col check coil.
How do you adjust the brakes on John Deere LA105?
Put the mower up on a wooden block to get the wheel off the ground. Pry off the plastic bolt cover, remove the bolt with a #12 metric socket I believe, remove the wheel. Unbolt the gear drive from behind the wheel and install it on the replacement wheel.
How do you tension mower belt on LA105 john deere?
You do not need to tension the mower belt because when you lift the yellow lever the belt is automatically tensioned. I had the same question about 3 days ago and when I turned the handle it got tighter. To ADD...the deck belt drive tension can be adjusted...where the cable comes to the deck from the drive 'ON' handle...it is in a bracket, take cotter pin out and on the inner part there will be a small black plastic piece attached to that side of the cable...pull cable gently out and up of the bracket...the bracket will have two 10mm bolts...loosen them (no need to remove) and you can adjust the tension... SO put the cable in and test by hand how tight the belt is...adjust the bracket to the position that works best for your mower...make sure you tighten the bracket down good then in reverse put the cable back in its place in the bracket...hope this helps and not confuse...also here is a youtube link...is for a l110 but works the same way! good luck!! http://www.youtube.com/watch?v=K5T-IDIZYuE
How ti install a drive belt on a john deere 240 lawn mower?
You need a good socket set and a torque wrench. Remove plastic covers from right and left sides. Belt guides must be loosened (but do not take nuts completely off, just enough to get new belt on), Start the belt from the back and work it over the left and right guides, tighen nuts (torque back to 35 lbs), then work belt around the tension guide, now with torque wrench still on tensioner, use the wrench to pull the tensioner forward and work belt over the front engine puller, tighten tension pully nut to 35 pounds and replace covers. I use honda-tight (blue) will all nuts and fastners.
