0
What is the default sequence for loading the configuration file on a router?
Wiki User
∙ 13y ago
NVRAM, TFTP,Console
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What tcp ip configuration specifies the address of a router?
The "default gateway" is your router.
What is reset botton in router?
The reset button in a router let you remove all the configuration you do and gives you the default configuration from factory.
What is the default configuration register setting for a cisco router?
0x2102
Which default EIGRP configuration must be modified to allow a router to advertise sub-nets that are configured with vlsm?
Which default EIGRP configuration must be modified to allow an EIGRP router to advertise subnets that are configured with VLSM
What is the default administration key code to change the setting on the Cisco 1841 router?
When resetting a Cisco 1841 router, the default password recovery and administration key is "confreg 0x2142." This allows you to reset the router with a new configuration.
What steps must be taken to remove the changes and return the router to the default configuration?
Reload the device.
If a router cannot find a valid configuration file during the startup sequence what will occur?
The router will prompt the user for a response to enter setup mode.
Which default EIGRP configuration must be modified to allow an eigrp router to advertise subnets that are configured with vlsm?
autosummarization
What is the first configuration change you should make when you first intall a router?
It is always good practice to change the default password to something else. If it is a wireless router you should also change the default SSID and enable an encryption method.
Which names correctly identify the CLI mode represented by the prompt for Switch-East4?
line configuration mode user executive mode * global configuration mode privileged executive mode interface configuration mode * enable mode8 What command is used to change the default router name to Fontana? Router# name Fontana Router# hostname Fontana Router(config)# name Fontana * Router(config)# hostname Fontan
If a router is booting with its default configuration register setting and its NV RAM lacks boot system commands from where will the router try to load the IOS image first?
Flash memory
What is the purpose of NV RAM on a Cisco router?
That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.
