0
What is the demand load for 3 ranges rated 9KW and 3 ranges rated at 14KW?
Wiki User
∙ 13y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the difference between full load amps and running load amps?
Full load amps is the maximum rated amps that the motor should draw according to its nameplate rating. Running load amps is the actual amperage the motor is drawing at that point in time when the test is taken. Some motor loads vary depending on if the load is cyclic. The reading on this type of motor would be from no load amps to full load amps.
Why does load shedding occur?
Load shedding happens when there is not enough electricity available to meet the demand of all customers, and an electricity (public) utility will interrupt the energy supply to certain areas. It is a last resort to balance electricity supply and demand.
What does roof load rating mean?
The roof load is a rating that determines how many pounds per square foot the roof will withstand. Most roofs are rated above 300 pounds per square foot or more.
Where is the load on a hammer?
The load is on the shaft.
What is the force on the load for a catapult?
load force
How can calculate maximum demand load?
maximum demand load can be calculated as: # maximum demand=demand factor * Connected load or by # maximum demand = connected load * Diversity Factor Note: Demand factor and diversity factor are NOT same
What is hydrothermal scheduling?
according to the variable load demand which generating unit is kept to be on , is most economical to satisfy particular load demand is call optimal scheduling.
What is maximum demand?
An electricity board will be fixed some amount of load for consumer (industry or commercial) as per consumers requirement.That is maximum load or maximum demand.
What is the Need of parallel operation in alternator?
load demand
How to increase load on a bus in power system.Does it means to increase the bus active power demand or reactive power demand or both?
You can increase load on a bus power system by increasing the bus active power demand ans reactive power demand.
What is the demand load in amps for a range with a 2.4kW single phase at 220V?
That load would be 10.9 amps.
What is load forecasting?
Load forecasting is used by power companies to anticipate the amount of power needed to supply the demand.
Is a microwave oven an example of a load?
Yes, a microwave oven is an electrical load that places a demand on the power grid.
What measured load can you put on an electrical panel?
If you have a measured continuous load of say 80 Amps, you would want to have a panel rated at 100 A. For continuous load you want to be at 80% of rated capacity.
What is the no-load voltage of a power supply that produces 24 volts at full load with a percent regulation of 10?
the voltage regulation (as a percent) = |V(no-load) -V(rated)|/|V(rated)| * 100 so if V(rated) = 24 V voltage regulation =10% then V(no-load) = 26.4 V
Can I combine 2 110v 15 amp outlets on a generator to power a single 30 amp 110v outlet on my boat?
The short answer, no. The long answer - A 15a 110v current tap can supply approximately 1650 watts. A 30a 110v load would assume a demand of 3300 watts. Splicing multiple cables together to supply this load would be an unsafe practice, as it would be possible for one or the other cables, or receptacles to become overloaded, creating a possible fire hazard. Assuming the generator is rated above that load demand, it would be much safer to add a correctly rated outlet to the generator, and utilize a properly rated cord for connection.
What is the speed of DC series motor at no load?
No load speed is the speed that the motor run when it has no load, i.e., the motor is separated from the engine, that speed is than greater than the rated speed, because the rated speed is the speed whwn the motor are linked to the load and it is the full load.
