10HZ. Enjoi!
There is a difference. For one thing, Australia works at 50hz and America at 60hz, and in domestic supply, Australia works at 240v and America at 110v.
No 50Hz
yes
you can't
You don't.
ONE THING FOR SURE THERE IS NO CHANGE IN VOLTAGE IF SAME EQUIPMENT WE ARE TALKING ABOUT. THE ISSUE HERE IS THE CHANGING LOAD FREQUENCY 60HZ TO 50HZ OR VICE VERSA. FOR EXAMPLE THE MOTOR HORSEPOWER AND R.P.M. WILL BE APPROXIMATELY 90 AND 83 PERCENT OF THE NAMEPLATE SPECIFICATIONS, ALSO THE FULL LOAD RUNNING TORQUE WILL INCREASE APPROXIMATELY 8 PERCENT IF USED FROM 60HZ TO 50HZ.
Voltage has nothing to with frequency
One way would be to hook it up to a supply (by itself, with no load) and measure the speed with a contact tachometer. If your supply is 60Hz, and the motor speed corresponded to one of the standard motor speeds, it would be a pretty safe bet you had a 60Hz motor. If the speed was about 20% faster than a standard speed, the motor is probably a 50Hz motor. Or 20% slower if you were running a 60Hz motor on 50Hz For instance, a 1750 RPM 50Hz motor would spin at about 2100 RPM if you ran it on 60Hz.
No! Normally not, the recistance in the windings is to hig on 60Hz and the pump motor has not power enough to work propelly. This happened to myself when I connected my Whirpool AWE 7519 to 230V 60Hz. Europian model for 50Hz.
No, 120 v is not enough.
Yes, no problem.
No