0
What is the difference between a router's running configuration and startup?
Wiki User
∙ 13y ago
The startup config is what has been saved to the memory (using write mem) and is used when the router is powered on.
You can change the startup config after it has been powered up, this would be the running config. If you power the router off without saving the changes, it would revert to the startup config.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What is difference between running and walking?
You get to mcdonalds faster running
What is the difference between an earthtquake and a fault?
The same as between running and legs.
What is the difference between running meter and linear meter?
None.
What is the difference between running feet and square feet?
1100
What is the difference between Amish and ameninites?
The Amish and Mennonites have very few difference. Mennonites will however have electricity, running water, and running cars where Amish will not.
What is the difference between jordans and jays?
There is not much of a difference between Jordan's and Jay's. One is a running shoe the other is a jumping shoe.
What is the difference between a full back and a running back?
Full backs are fat and running back are elesive
What is the difference between track and cross country?
Track is running in circles and cross country is just running.
What is difference between trail and road surface for running?
The difference between trail and road surface for running is that trail is usually dirt roads as opposed to tarred (tarmac) surfaces associated with road surfaces.
What is the difference between an active application and an icon?
The difference between an icon and active application is that an icon is a small image seen on a computer screen and it represents a program but is not running. An active application is one that is running in the foreground of a computer.
What is accomplished by the command copy tftp running-config?
This command will allow you to copy a configuration from a TFTP server to the running configuration of a Cisco device. When you issue the command you will be prompted for further details about the TFTP server. The new configuration will replace the active one (or running configuration) and make any necessary changes.
