Set up time is the amount of time before the clock edge that the input signal needs to be stable to guarantee it is accepted properly on the clock edge.
Hold time is the amount of time after the clock edge that same input signal has to be held before changing it to make sure it is sensed properly at the clock edge.
Whenever there are setup and hold time violations in any flip-flop, it enters a state where its output is unpredictable: this state is known as metastable state (quasi stable state); at the end of metastable state, the flip-flop settles down to either '1' or '0'. This whole process is known as metastability
Flip-flop setup time refers to the minimum amount of time that the data input must be stable before the clock edge for the flip-flop to correctly latch the data. Hold time, on the other hand, refers to the minimum amount of time that the data input must be stable after the clock edge for the flip-flop to correctly store the data. In summary, setup time is the minimum time before the clock edge, while hold time is the minimum time after the clock edge for proper operation of the flip-flop.
Depends on the animal, but in general male produces sperm, female produces eggs, and MAY hold fertilized eggs until they grow (but not always)
There probably won't be any difference that you can see with your eyes, though 256MB will have twice as many capacitors because it stores twice as many bits.
The main reason is that Mercury has almost no atmosphere which would hold the heat in. So the temperature on the side which is facing away from the Sun can plummet.
In most of the world, there is no difference, because the metric system is the customary system.In a few isolated hold-out corners of the world, such as the USA, the English system is still customary.In those places, the main difference between the metric system and their customary system is that theircustomary system is a lot harder for their people to learn than the metric system would be.
A callable bond is where the issuer has the ability to redeem the bond prior to maturity. A callable bond is where the bond hold has the ability to force the issuer to redeem the bond before maturity. Hope this helps.
What is the diferent between keep and hold
ml,/,
contact tob continuous with others
I do not know the answer.The difference between mass and capacity is that capacity is how much something can hold and mass is the weight of an object.
Capacitance is quite literally the capacity to hold charge at a given potential difference.
Pincer does not hold things like pliers can.
Hold Down the space bar while powering up the terminal, then you can setup the address etc on it.
The difference between a pillow and a bee is a bee has a stinger on its back so it can sting the pillow. The pillow can do nothing, but hold your head.
women hold the sperm to produce a baby.
To avoid setup time violations:The combinational logic between the flip-flops should be optimized to get minimum delay.Redesign the flip-flops to get lesser setup time.Tweak launch flip-flop to have better slew at the clock pin, this will make launch flip-flop to be fast there by helping fixing setup violations.Play with clock skew (useful skews).To avoid hold time violations:By adding delays (using buffers).One can add lockup-latches (in cases where the hold time requirement is very huge, basically to avoid data slip).
Pipette can hold a small amount of liquid but a graduate cylinder can hold more and its good for accuracy.
an object(n) is something you can hold to object (v) is to "not agree with"