For medium length lines the shunt capacitance is uniformly distributed along the length of transmission line..
For simplicity in the calculations,
Now in T method the tolal line capacitance is lumped or concentrated at the mid point of the line.While in Pie method the capacitance is divided into two halves whith one half lumped near sending end and other half near the receiving end,The capacitor near the sending end does not contribute any line voltage drop but it should be added with line current to get lotal sending end current.
In Wait for Graph the request edge is a directed edge Pi → Pj which indicates that process Pj is holding a resource that process Pi needs and thus Pi is waiting for Pj to release its lock on that resource. It does not have any allocation edge.In case of Resource Allocation Graph the request edge is a directed edge Pi → Rj which indicates that process Pi is requesting resource Rj. It has an allocation edge from Rj→Pk when the resource Rj is allocated to process Pk.The way the graphs are drawn are also different but both of them are used in deadlock detection.
This question is from Bohr's atomic model. The total length of the orbit is an integral multiple of the wavelength of an electron. The relation given by 2(pi)(radius)=n(wavelength), where n is the principal quantum number. Proof of this came later from De-Broglie's hypothesis, (wavelength)=h/(linear momentum) It is- (wavelength)=h/mv .....I From Bohr's model (Quantization of angular momentum), mvr=nh/2(pi) So, 2(pi)r=n(h/mv) From I, 2(pi)r=n(wavelength)
1.transient analysis 2.discrete time analysis 3.hybrid pi model 4.location of poles
the piecewise linear chaotic map is defined as follows: xi+1=Fpi(xi)= xi/pi if 0<=xi<pi (xi-pi)/(0.5-pi) if pi<=xi<0.5 Fp(1-xi) if xi>=0.5 where 0<=xi<1 and the control parameter 0<pi<0.5
float pi = 3.142; // Note: pi is an irrational number, there is no "exact" value of pi
There is not much difference between Re model and hybrid model. The only difference being hre(vi/vo) reverse voltage gain. The remainig parameters are comparable. hie=beta*re hfe=beta hoe=ro
Pi is 3.1415926535... Pie is a dessert
22/7 is 3.142857 Pi is 3.141592 The difference is approximately 0.001265
diameter
Relation between phase difference and path difference is path difference/wavelength=phase difference/2*pi
A straight angle is pi radians (180 degrees) so the difference is pi radians.
In abs. PSK only instant phase for the incoming bits are considered. For DPSK, the difference between previous phase and the present phase is considered. Example: If BPSK is used, then for 0 if phase if pi and for 1 it is 0, then for abs. BPSK the phase states for the bit stream 1010 will be 0,pi,0,pi for DPSK, we assume initial phase is zero and a rule that , if incoming bit is zero, then phase difference is 0 and if it is 1 then, phase difference is pi. So, phase difference will be--pi,0,pi,0 Instant phase will be, pi,pi,0,0....Easy!!
This is PI, pi = 3.14159265...... A circle is the round thing, like your pies! The area of a circle is measured using (Pi)(radius to the power of 2). Circumfrance of a circle is (Pi)(Diameter of circle).
pi radian
3.1415926589 or pi just joking its just 3
balanced pi model for a long transmission line.
There is no such letter because there is no interval between pi and pi.