A surge is an over voltage and over current situation and a brownout is an under voltage situation.
Surge suppressor, as name suggests suppresses and regulates the voltage and makes the power constant in a case of a spike or surge. While a protector simply detects the surge and turns the unit off. Suppressor is good for things like computers, where you don't want to keep turning on and off.
-The tension of the cable (the tighter, the less sag, but this can cause other problems if too tight) -The temperature outside (the higher the temperature, the more it will sag) -The amount of current flowing through the cable (the more current, the hotter the conductor will get = more sag) -The type of cable (aluminimum will sag more than copper; ACSR will sag less than straight aluminimum).
i know someones going to be on this sooooooooo....... they sag because the hydro workers know, from the heat the cbles will sag during the summer, so they start the sag so they cant sag anymore
The plural of sag is sags, not sag's! Sag is caused by the weight of the conductor between its supports, and is (a) unavoidable and (b) necessary to allow for the conductor's expansion and contraction during variations in temperature. When surveyors design a power line, the amount of necessary sag is calculated and built into the design, while ensuring that the clearance between the conductor and the ground remains within safe limits.
What channel is Btn on direct tv
sag is the difference between the point of support to the lowest point of the conductor.
It melts to protect the BTN circuit in an overload situation.
There is likely no difference. Neither is accepted terminology for a surge suppressive device (SPD). If these products have been tested by safety organizations such as CSA (Canada) or UL (US) or tested to international surge standards (IEEE, IEC), then they should bare the correct terminology, otherwise, they are not tested to provide protection to equipment during a surge. Surge Absorber acts as a load that utilizes the high current until it exhausts. but the surge suppressor diverts the high current into ground without reaching the sensitive parts of the circuit. Surge absorber degrades faster than a surge suppressor.
Behind The News
A surge is an over voltage and over current situation and a brownout is an under voltage situation.
A pyrcoclastic flow is is much denser than a pyroclastic surge, as a large portion of it is composed of ash and rock. A pyrcolastic surge is composed more of gas.
sag
demoines
Bhutan Ngultrum (BTN)
SAG
ab