Want this question answered?
How to calculate the ratio of the inlet-to-exit area of the nozzle
My baby brothers baby bottle has a nozzle the size of an elephant!
the simplest engine that is made up of a burning chamber and a nozzle is a rocket.
One disadvantage in the convergent-divergent nozzle as a shock wave can take place in the nozzle A nozzle is a device that converts pressure energy to kinetic energy (increasing fluid velocity on the account of static pressure) For a convergent nozzle there is no disadvantages as it can raise the fluid velocity only for the sonic speed the convergent-divergent type raises the velocity to over than sonic speed making supersonic flow, this could make a shock wave in the nozzle that turns the supersonic flow to subsonic flow
It varies. I have seen a range of between 50 psi to 225 psi. It is affected by distance, size of water lines and their configuration and elevation change from source to the hydrant, as well as the type of pressurization, gravity or pump. On average though 80 to 100 psi. Of course a larger nozzle would decrease the residual pressure while a smaller nozzle would tend to increase residual pressure. 125 psi is about the maximum pressure for a "hand line" in order to be manageable.
SR nozzle means "Self Reinforced Nozzle".
0.42
Convergent nozzle indicates nozzles will converge with an end closing together at the end divergent nozzles increase size at the end. If air flows in this direction: ---> Convergent nozzle > Divergent nozzle <
The Wedco Nozzle is a CARB compliant spill-proof gas can nozzle. With the nozzle in place you can invert your gas can and it will not leak. Then simply push the nozzle lock and push the nozzle against the rim of the filling throat of the tank you're filling to start the flow of fuel. If you lift the nozzle away from the rim the flow stops.
You get the rocket nozzle after you open the rocket nozzle box in the level with the blooper boss.
About 2 inches
Jump on a red box with a weird symbol on on it and take nozzle that comes out. You have obtained the rocket nozzle.
Use the turbo nozzle.
Pressurize it through a small nozzle. It will freeze at the nozzle.
My baby brothers baby bottle has a nozzle the size of an elephant!
How to calculate the ratio of the inlet-to-exit area of the nozzle
As long as the hole through the nozzle was the same size for all three, then, yes.