Want this question answered?
The effect of dry steam entry into a wet steam filled vessel will promote condensation in the vessel. However, it will be less wet because of the dry steam.
Basically, if you fill a room with steam and pass an electrical current through it... Does anything interesting happen?
Snow because snow is a solid and steam is a Gas and science has shoe that sound travels fastest through solids
Any time an object is slowed down by friction, most of the kinetic energy is converted to thermal energy.Any time an object is slowed down by friction, most of the kinetic energy is converted to thermal energy.Any time an object is slowed down by friction, most of the kinetic energy is converted to thermal energy.Any time an object is slowed down by friction, most of the kinetic energy is converted to thermal energy.
steam. It has to go through a phase change, which takes additional energy to get there.
Steam turbine nozzle clearance is the total energy content available in steam. This is through a valve.
Nozzles are designed to increase the steam velocity.
A NOZZLE IS A DUCT WHICH CONVERT HEAT ENERGY INTO KINETIC ENERGY.IT INCREASES VELOCITY OF FLUID PASSING THROUGH IT ,AT THE EXPENCE OF PRESSURE. STEAM EXPANDS IN NOZZLE FOLLOW RANKINE CYCLE.FLOW THROUGH NOZZLE IS ISENTROPIC. mritunjay04@gmail.com
1) convergent nozzle 2)divergent nozzle
In a single stage steam turbine the steam is run through a nozzle to give it maximum velocity, thus the blades move at very high speeds, impractical for some applications, and only some of the energy is used, about 85-90%. In multi-stage or compound turbines the steam goes through a nozzle to increase its velocity, then after going through a set of blades, it is run through another nozzle to bring the steam back up to the correct velocity. After multiple stages there is no longer enough pressure left to up the velocity of the steam. This method increases the efficiency of the turbine and also decreases wear on the components caused by the high speed of a single stage.
The Steam Turbine is the one which steam worked pressured Hot and exited then the shaft of the turbine starts to and fro motion due which energy is injected through nozzle in the receiver.
yes
A convergent-divergent nozzle is generally used in steam turbines. This is because it drives generators in producing electricity with the use of turbine rotors with curved axes.
It sends hot gases from the combustion chamber to the 1st stage turbine blades at the correct angle and speed
When dry and saturated steam is caused to expand in a nozzle,the actual measured steam flow is found to be greater than the theoretical calculated flow.This is due to the time lag in the condensation of steam & the steam remains in dry state instead of wet. Such a steam is called supersaturated steam. This time lag is cause due to the the face that, the converging part of the nozzle is to short and the steam velocity is too high that the molecules of steam have insufficient time to form droplets.
The negative effect of a steam boat is that it causes a fire and can explode due to steam pressure.
it is not based on bunoullies theorem it is based on mach number.when sonic speed of steam converted to supersonic steam by nozzle vacuum is created.